User manual PHILIPS SCD510

[. . . ] Congratulations on your purchase and welcome to Philips AVENT!To fully benefit from the support that Philips offers, register your product at www. This Philips AVENT baby monitor provides round-the-clock support by ensuring you can always hear your baby clearly without any distracting noise. The DECT technology guarantees zero interference from other wireless appliances and a crystal clear signal between the baby unit and the parent unit. [. . . ] Out of range alert When the parent unit is out of range of the baby unit, the parent unit beeps from time to time. The LINK light on the parent unit flashes red. Note:The LINK light on the parent unit also flashes red when the baby unit is switched off. Microphone sensitivity You can set the microphone sensitivity of the baby unit to the desired level with the SENSITIVITY button on the parent unit. You can only change the microphone sensitivity when a connection between the baby unit and the parent unit has been established, i. When the LINK light on the parent unit lights up green continuously. , The sound level lights light up for approx. seconds to indicate the current sensitivity level. Briefly press the volume + and - buttons on the parent unit until the desired microphone sensitivity level for the baby unit has been reached. , one light on = minimum sensitivity level , all lights on = maximum sensitivity level Tip: Switch off the nightlight when you operate the baby unit on the non-rechargeable batteries. To stop the paging alert tone, press the PAGE button again or press any button on the parent unit. Note:When the microphone sensitivity of the baby unit is set to a high level, it picks up more sounds and therefore transmits more often. Reset function This function allows you to reset the parent unit and the baby unit to the default settings. You can use this function if problems occur that you cannot solve by following the suggestions in chapter `Frequently asked questions'. 1 Press the on/off button to switch off the parent unit. Remove the small plug from the parent unit and the adapter from the wall socket (Fig. Put the small appliance plug in the parent unit and put the adapter in the wall socket (Fig. Wait for the parent unit to complete its automatic restart at its default settings before you release the volume down (-) button. proceed in the same way to reset the baby unit. Default settings Parent unit - Loudspeaker volume: 1 - Microphone sensitivity: 3 Baby unit - Loudspeaker volume: medium - Nightlight: off accessories Belt clip If the batteries of the parent unit are sufficiently charged, you can take the unit with you inside and outside the house if you attach the unit to your belt with the belt clip. This allows you to monitor your baby while you are moving around. Connecting the belt clip 1 Snap the belt clip onto the parent unit (Fig. [. . . ] Why is the operating time of my parent unit shorter?Answer When the parent unit has been charged for the first time, the operating time is less than 24 hours. The rechargeable batteries only reach their full capacity after you have charged and discharged them at least four times. The volume of the parent unit may be set too high, which causes the parent unit to consume a lot of energy. [. . . ]