User manual PHILIPS SCD530

[. . . ] Some of the following information may not apply to your particular product; however, when using baby monitor equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1 Read these instructions. 7 Do not block any ventilation openings. install in accordance with the manufacturer's instructions. 8 Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat. [. . . ] , The number of the lullaby appears on the display together with the lullaby symbol K. 8) , The number of the lullaby and the lullaby symbol K disappear from the display. To select another lullaby when a lullaby is playing: Press the lullaby button K on the baby unit within 2 seconds to toggle through the list of lullabies. To stop the paging alert tone, press the PAGE button again or press any button on the parent unit. Note: If you do not press the lullaby button K for more than 2 seconds, the lullaby shown on the display starts to play. Humidity When there is a connection between the baby unit and the parent unit, the humidity level is shown on the display of both units. The optimal humidity level is between 40% and 60%. It is very important to maintain the correct humidity level as it helps to protect your baby from irritation of the mucous membranes, dry and itchy skin, chapped lips and a dry, sore throat. When the mucous membranes do not function optimally, they cannot give your baby full protection from all kinds of germs. This increases the chance of your baby catching a cold or the flu, and reduces its resistance to infections from mold and bacteria. note:The baby monitor only measures the humidity level. You cannot adjust the humidity level with the baby monitor. Out of range alert When the parent unit is out of range of the baby unit, the parent unit beeps from time to time and the message `Not linked' appears on the display. The LINK light on the parent unit lights up red. Note:The message `Not Linked' also appears on the display of the parent unit when the baby unit is switched off. Menu options The following functions are operated in the menu of the parent unit. Menu operation - general explanation Note: Menu functions can only be operated when a connection has been established between the baby unit and the parent unit. , The new setting flashes twice and then disappears from the display. You can set the microphone sensitivity of the baby unit to the desired level. You can only change the microphone sensitivity when a connection between the baby unit and the parent unit has been established, i. When the LINK light on the parent unit lights up green continuously. Select the desired microphone sensitivity level for the baby unit with the + and - buttons. [. . . ] Why does my baby monitor manage a much smaller distance than that?Why is the connection lost every now and then?The parent unit may be switched on during charging. Switch off the parent unit during charging. [. . . ]