User manual PHILIPS SCE4430

[. . . ] Never use the power pack in moist places or close to water. Do not expose the power pack to rain or excessive moisture. Do not place inflammable, explosive or hazardous objects near the power pack. Use of an other type of adapter may damage the power pack and/or your device. [. . . ] 3 Insert the connector tip into the power supply jack of the device. > The device will now derive it's power from the power pack. > If the device has a charging indicator , it will indicate that the device is being charged. Note: If you are unable to solve a problem by following the above hints, try resetting the power pack by pressing RESET. Tip: For several portable devices (5V), a USB connection cable is supplied with the original device (e. In this case, you can also use this cable to charge your device. > One, two or three LEDs light up in the power indicator (1), indicating the current battery status. 5 Connect the power plug of the USB charger to a wall outlet. > The power indicator LEDs (1) will flash one after another, indicating that the battery is being charged. > When all LEDs light continuously the battery is fully charged. 6 Disconnect the battery pack from the AC power adapter and disconnect the AC power adapter from the wall outlet. Power pack runs out of power quickly ­ Power pack not fully charged before using. ­ Supplied AC power adapter was not used for charging power pack. Only use supplied AC power adapter for charging power pack. Power pack cannot be charged ­ Improper connection between power pack and wall outlet. Check that power cord is properly inserted into both wall outlet and AC power adapter. Check that adapter plug is properly inserted into the INPUT 5V DC Jack of the power pack. ­ Problems with the electrical circuit of the power pack. Take the power pack to your local distributor. Note: If you are unable to solve a problem by following the above hints, try resetting the power pack by pressing RESET. Solution The power pack does not charge connected device ­ Voltage of device does not correspond with that of power pack. ­ Improper connection between device and power pack. [. . . ] Disposal of your old product Your product is designed and manufactured with high quality materials and components, which can be recycled and reused. When this crossed-out wheeled bin symbol is attached to a product it means the product is covered by the European Directive 1902/96/EC. please inform yourself about the local separate collection system for electrical and electronic products. Please act according to your local rules and do not dispose of your old products with your normal household waste. [. . . ]