User manual PHILIPS SCF256/00

[. . . ] The outside of the beaker can become hot when it is filled with hot water from the flask. The times stated in the warming reference guide should be considered as guidelines. When you heat a bottle or container according to the times indicated in the warming reference guide, remove the bottle or container from the beaker immediately after this time has passed. If you leave it in the beaker longer, the drink or food may become too hot. [. . . ] €¯2) 2 Turn the pouring lid anticlockwise (1) and lift it off the flask (2) (Fig. €¯4) Note: Do not overfill the flask to avoid splashing of hot water. 4 Place the pouring lid back onto the flask (1) and turn it clockwise to fix it (2). €¯5) Note: Make sure the pouring lid is fixed properly and is closed. 5 Place the beaker over the flask again (1) and turn it clockwise to fix it (2) (Fig. The thermal bottle warmer is now ready to go. Heating up a bottle or container 1 Turn the beaker anticlockwise (1) and lift it off the flask (2) (Fig. 2 Place a bottle or container in the beaker (Fig. 3 Turn the flask anticlockwise (1) and lift it off the protective lid (2) (Fig. 4 To open the pouring lid, press firmly on the OPEN button in the centre of the lid (Fig. Note: Always make sure the water level stays below the neck of the bottle or container. Do not exceed the MAX indication on the beaker. 6 Place the protective lid on the beaker (1) and turn it clockwise to fix it (2). This ensures fast and convenient warming of the drink or food (Fig. 7 To close the pouring lid, press the CLOSE ring (Fig. Tip: Consult the warming reference guide for indications of warming times (see chapter ‘Warming reference guide’). 8 Carefully remove the bottle or container from the beaker and check the temperature of the drink or food. Note: Check the temperature of the drink or food before you feed it to your baby. If you think that the temperature is too low, put the bottle or container back into the beaker and let it heat up for a few more seconds. 13) provides indications of the warming time required for warming up milk in the thermal bottle warmer. [. . . ] 3 Rinse the beaker and flask thoroughly with fresh water. 4 To clean the pouring lid, turn the top part anticlockwise (1) to remove it from the bottom part (2). Clean both parts with warm water and some washing-up liquid and rinse them thoroughly with fresh water. €¯14) Note: Handle both parts of the pouring lid with care. [. . . ]