User manual PHILIPS SCF260

[. . . ] Care of your iQ Bottle and Baby Food Warmer Always unplug the warmer and allow it to cool before cleaning. Wipe the inside and outside of the warmer with a damp cloth. Using cool pre-boiled or filtered water in your warmer may reduce limescale build-up. When the warmer needs de-scaling, the mode and starting temperature symbols will flash on the electronic display. [. . . ] · Always use a cloth when removing bottles, cups, jars and tins from the warmer. · Always check feed temperature before feeding. · For microbiological and hygienic reasons, once heated, milk and food should not be reheated again. · Never immerse the warmer or power cord in water. · This appliance is intended for use by responsible persons, keep out of the reach of small children and the infirm. · This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience or knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. · Children should be supervised to ensure they do not play with the appliance. · Failure to follow de-scaling instructions may cause irreparable damage. · There are no serviceable parts inside the iQ Warmer. Do not attempt to open, service or repair the warmer yourself. The warmer is beeping · If ml/oz symbols flash, and the warmer beeps twice, insufficient water has been placed in the warmer. Unplug the warmer, discard the milk or food and empty any remaining water. Follow instructions from Step 1 onwards. · If all volume symbols are flashing, and the warmer beeps intermittently for 30 seconds then the cycle is complete. Follow Step 8 onwards to remove the bottle or container from the warmer. Press the Power/Mode Selection Button and the warmer will beep and return to default settings. Once the correct mode, starting temperature and volume have been selected, press and hold the Volume Selection/Start Button until the warmer beeps. If the lid is opened at any time during the warming cycle, the lights on the display panel will flash and the warmer will stop and return to default settings. In order to reset the warmer after the lid has been opened, empty out any residual water, then follow instructions for use from step 1 onwards. Since this could occur at any stage of the warming cycle, milk or food should be discarded for safety reasons. The maximum volume that may be selected when warming food from frozen is 230ml/8oz. To stop the warming cycle To start the warming cycle Philips AVENT is here to help: www. philips. com/AVENT GB Call FREE on 0800 289 064 IRL Call FREE on 1800 509 021 AU 1 300 364 474 42133 5435 180 If the lid is opened during warming cycle AVENT, Suffolk, CO10 7QS, England Philips of Holland. All logos brands and product names are trademarks or registered trademarks of their respective holders and are hereby recognised as such. Difficulty setting the appropriate amount of frozen food 6 7 8 iQ Bottle and Baby Food Warmer Thank you for choosing Philips AVENT The Philips AVENT iQ Bottle and Baby Food Warmer is the only warmer with advanced iQ Technology, designed to smartly and accurately adjust warming time based on contents and amount. Whether warming milk or baby food that is frozen, chilled or at room temperature, the iQ Bottle and Baby Food Warmer heats quickly, safely and evenly ­ with no hot spots. [. . . ] Philips AVENT recommends removing and using the contents immediately when the warming cycle is complete, even before the warmer automatically turns off. Open the lid carefully to avoid any residual steam. Be careful when opening the lid as steam can escape and cause injury. Use a cloth when removing the container, as it may be hot (vii). [. . . ]