User manual PHILIPS SCF271

[. . . ] Then in Mode 1, run a full sterilising cycle empty with the lid on, using exactly 90ml of water. Pour 100ml vinegar mixed with 200ml cold water into the steriliser. Allow to stand in the unit until any limescale has dissolved. Drain and rinse the inside of the steriliser thoroughly. [. . . ] · Do not use softened water in the steriliser. · The lead supplied must not be used on any other appliance and no other lead should be used with the iQ24 Steriliser. · Failure to follow de-scaling instructions may cause irreparable damage. · There are no serviceable parts inside the iQ24 Steriliser. Do not attempt to open, service or repair the iQ24 Steriliser yourself. · CAUTION: This appliance is intended for use by responsible persons, keep out of the reach of small children and the infirm. · This appliance is not intended for use by persons including children with reduced physical, sensory or mental capabilities, or lack of experience or knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. · Children should be supervised to ensure that they do not play with the appliance. DISPOSE OF THROUGH SEPARATE COLLECTION ROUTE FOR WASTE ELECTRICAL EQUIPMENT For our complete catalogue of mother and baby care products and breastfeeding video or DVD GB: Call FREE on 0800 289 064 GB ONLY (9am­4. 30pm Mon-Fri) IRL: Call FREE on 1800 509 021 IRL ONLY (9am­4. 30pm Mon-Fri) AU: 1 300 364 474 (Australia National) Philips of Holland. All logos brands and product names are trademarks or registered trademarks of their respective holders and are hereby recognised as such. 42133 5435 060 #2 (10/07) www. philips. com/AVENT AVENT Ltd, Suffolk, CO10 7QS, England (AVENT Ltd is a member of the Philips Group) 6 iQ24 Electronic Steam Steriliser Instructions for use The Philips AVENT iQ24 Electronic Steam Steriliser is one of a new generation of intelligent products from Philips AVENT. The iQ24 Steriliser uses the intensive heat of steam to eliminate harmful bacteria helping you sterilise your baby feeding equipment as safely and quickly as possible. There are two different modes for greater convenience: Mode 1 (Optional six hour mode) runs a single 6 minute sterilising cycle, then keeps the contents sterile for 6 hours, providing the lid is not removed. Measure and pour in exactly 90ml of water if selecting Mode 1 OR 200ml of water if selecting Mode 2. Slide the lower basket onto the central stem. Thread 2 screw rings onto the central stem. Slide the bottle rack down the central stem, with the neck facing down, until it rests on the top screw ring. Place the teats through the centre of the holes in the bottle rack onto the lower basket. Thread 4 screw rings onto the central stem. Place inverted bottles in the bottle rack and push the upper basket onto the central stem until it rests on the catch. Place dome caps and tongs into the upper basket. The upper basket is not required when sterilising 330ml bottles. Place the assembled unit into the steriliser body and put the lid on. Put the lead into the back of the steriliser body and plug into the mains supply. [. . . ] If necessary, shake excess water from items before assembling. 6. 7. 8. The tongs can be used to remove small items and to pull the sterile teats through the screw rings of the bottles. Removed items must be used/assembled immediately or re-sterilised. Expressed milk can be stored in a sterile breast milk container in the refrigerator for up to 48 hours (not in the door) or in the freezer for up to 3 months. [. . . ]