User manual PHILIPS SCF276

[. . . ] Mix one sachet of citric acid (10gms) with 200ml of water*. Activate Mode 1 and leave for 1-2 minutes. Unplug and leave to stand for 30 minutes. Drain and rinse the inside of the steriliser. [. . . ] · CAUTION: This appliance is intended for use by responsible persons, keep out of the reach of small children and the infirm. · This appliance is not intended for use by persons including children with reduced physical, sensory or mental capabilities, or lack of experience or knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. · Children should be supervised to ensure that they do not play with the appliance. DISPOSE OF THROUGH SEPARATE COLLECTION ROUTE FOR WASTE ELECTRICAL EQUIPMENT For our complete catalogue of mother and baby care products and breastfeeding video or DVD GB: Call FREE on 0800 289 064 GB ONLY (9am­4. 30pm Mon-Fri) IRL: Call FREE on 1800 509 021 IRL ONLY (9am­4. 30pm Mon-Fri) AU: 1 300 364 474 (Australia National) Philips of Holland. All logos brands and product names are trademarks or registered trademarks of their respective holders and are hereby recognised as such. 42133 5435 060 #2 (10/07) www. philips. com/AVENT AVENT Ltd, Suffolk, CO10 7QS, England (AVENT Ltd is a member of the Philips Group) 6 iQ24 Electronic Steam Steriliser Instructions for use The Philips AVENT iQ24 Electronic Steam Steriliser is one of a new generation of intelligent products from Philips AVENT. The iQ24 Steriliser uses the intensive heat of steam to eliminate harmful bacteria helping you sterilise your baby feeding equipment as safely and quickly as possible. There are two different modes for greater convenience: Mode 1 (Optional six hour mode) runs a single 6 minute sterilising cycle, then keeps the contents sterile for 6 hours, providing the lid is not removed. Mode 2 keeps contents sterile for up to 24 hours by continuously repeating the cycle, so you can have clean, sterile bottles day and night. As well as bottles and breastfeeding accessories, you can sterilise any other boilable items (please refer to the manufacturer's instructions regarding sterilisation). Please take a few minutes to read through the ENTIRE INSTRUCTION LEAFLET before using your iQ24 Steriliser for the first time. Also available at www. philips. com/AVENT Contents a) b) c) d) e) f) g) h) i) j) Lid 2 x Upper basket Bottle rack Lower basket (same as b) Central stem Steriliser body Measuring Cup De-scaler (citric acid) Tongs Lead and plug Before using your steriliser for the first time 1 90ml Sterilising in Mode 1 ­ 6 hour sterile period Sterilising in Mode 2 ­ 24 hour sterile period To sterilise up to six 125ml, 260ml or 330ml AVENT Bottles* 1 2 3 4 5 To load the Philips AVENT ISIS Manual Breast Pump 2(i) 2(ii) 2(iii) NB: Upper and lower baskets are identical Mode 1: 90ml Mode 2: 200ml 2(iv) 3 4 BEEP 6 7 BEEP BEEP 8 BEEP Before each use, wash items to be sterilised in mild soapy water, and rinse. Disassemble the ISIS Breast Pump and click the pump body into the slot in the upper basket and arrange the other breast pump components as shown. 2. 3. a) 4. Place remaining components of the pump in the lower basket. Up to six 125ml or 260ml bottles (not including screw rings, teats or dome caps) can be sterilised with the pump. Follow sterilising instructions on page 4. To remove sterilised items after a cycle b) BEEP BEEP BEEP BEEP X5 1 2 6 8 c) 5 6 7 8 d) BEEP X5 e) f) Display Control button g) h) Remove all items from inside the steriliser body. Measure exactly 90ml of water and pour in. Assemble the blue components (baskets, stem and bottle rack) and place into the steriliser. Connect the lead into the back of the steriliser and plug into the mains supply. The unit will display a flashing `0' to indicate you need to select a mode. One short press of the control button will display a flashing `1'. Hold the control button in for 2 seconds then release, and a rotating `0' is displayed. After the water has reached 100°C, it will turn to steam. When the sterilising cycle is almost complete a numerical countdown will be displayed (see `Electronic Display Guide'). [. . . ] (Please refer to `To remove sterilised items after a cycle' on page 5). Switch off at mains and unplug the lead from the back of the steriliser. Pour away any remaining water, rinse out the inside of the steriliser body and wipe dry. The end of a cycle is 6 hours after commencement 1. 5. When Mode 1 cycle is complete pressing the button will reset the unit. [. . . ]