User manual PHILIPS SCF355/00

[. . . ] ENGLISH 7 -- Check if the voltage indicated on the bottom of the appliance corresponds to the local mains voltage before you connect the appliance. -- If you need to use an extension cord, make sure it is an earthed extension cord with a rating of at least 13 amperes. -- Do not use the appliance if the plug, the mains cord or the appliance itself is damaged. -- Do not place the appliance on or near a hot gas or electric cooker, or in a heated oven. [. . . ] -- Food warming setting: Select this setting when you want to warm a container/jar of baby food. -- Milk warming setting for contents over and including 180ml/6oz: Select this setting when you want to warm a bottle of milk with a content over and including 180ml/6oz. Using the bottle warmer to warm milk 1 Put the mains plug in the wall socket (Fig. 2 Place a bottle in the bottle warmer (Fig. 3 Fill the bottle warmer with drinking water up to the level of the milk in the bottle. In case of large amounts of milk, the maximum level of water is approximately 1 cm below the top of the bottle warmer. An accurate water level ensures correct warming performance (Fig. See the warming reference table at the end of this chapter to check how long the milk needs to be warmed in the selected setting (Fig. 10 ENGLISH Note:The speed of warming milk depends on the amount of the milk warmed and on its initial temperature, i. 5 The orange light goes on when you select a setting. This indicates that the bottle warmer is on (Fig. 6 Check the warming reference table for the time required to warm the milk. Remove the bottle from the bottle warmer after the time indicated in the warming reference table has passed (Fig. This will create a slightly warmer result but without overheating. Caution: If you leave the bottle in the bottle warmer longer than the time indicated in the settings table, the milk may become overheated. Note: If you overheat breast milk, valuable nutrients and vitamins may be lost. 7 Always check the temperature before you feed your baby. Gently shake the bottle or milk storage container and check the temperature of the milk by sprinkling a few drops on the inside of your wrist (Fig. 8 Turn the knob back to the ‘off’ position. €¯10) Caution: If you do not turn the knob back to the ‘off’ position, the water keeps warming. Using the bottle warmer to warm baby food 1 Follow the same steps as indicated in the previous paragraph. 2 Make sure to stir the baby food during warming as it does not circulate automatically. [. . . ] Leave the solution in the bottle warmer until all limescale has dissolved. 4oz of cold water to descale the appliance. 2 Unplug the bottle warmer before you empty it (Fig. 3 Empty the bottle warmer and rinse its inside thoroughly. [. . . ]