User manual PHILIPS SDV3220

[. . . ] Try to mount aerial as high as possible ­ this will extend the range. If mounting inside - mount in such a way that the aerial is installed near a window which will give the aerial a clear view of the transmitter 3. Mounting the aerial in a loft will significantly reduce the signal received ­ typically by as much as 50%. Setting up a digital tuner with this aerial Digital TV tuners require you to program the tuner with the available channels in your area. [. . . ] If you have access to a rooftop aerial or another aerial which is currently connected to a digital tuner you may use that aerial to program the tuner. The channels will be memorized in the tuner ­ which will make aligning this aerial easier. Another method is to connect the aerial directly to your TV (not using tuner) and tune to analogue channels to find best location of the aerial. Then, re-connect the digital tuner - if you have adequate signal level you should be able to program the tuner. For indoor wall mount installation: NOTE: Complete all assembly work on the ground before installing on a wall or an aerial mast. 1. fig. 1 Attach main body to the L ­ bracket as shown, using cross head screw note the orientation of the bracket. Do not fully tighten the screw to allow for later adjustment (fig. Using the Wall bracket as a guide, mark position for the four 50mm wood screws. If possible locate a stud to screw into. Tighten all screws and nuts to firmly affix the aerial to the mast. Adjustment of the direction will be done by rotating the mast in its mount. Attach the cable to the connector on the underside of the unit and weather protection boot over the connection (fig. 6). 3. 4. 5. 8. 9. fig. 6 5 EN Connection to TV fig. 7 Connections to your TV As previously noted the amplifier (Power Injector + Power supply) must be placed in-line between the aerial and before any splitter or additional devices. Connect the coaxial cable from the aerial to the connector labeled AMP on the Power Injector. Connect Power Injector to the aerial input on your TV, Digital Set-Top box, Splitter and / or any other device. Note ­ some set-top boxes require an "F" type connector ­ use the adapter supplied. Connect the Power Supply DC plug to the Power Injector then plug the power supply adapter into a 230 Volt AC receptacle. [. . . ] Connect the Power Supply DC plug to the Power Injector then plug the power supply adapter into a 230 Volt AC receptacle. Safety Note -The power injector and power supply is for indoor use only!A note about coaxial cable - Your SDV3220/05 includes a 6m roll of RG-59 coaxial cable. [. . . ]