User manual PHILIPS SDV5121

[. . . ] Reproduction in whole or in part is prohibited without the written consent of the copyright owner. Trademarks are the property of Koninklijke Philips Electronics N. V. or their respective owners. Recycling Your product is designed and manufactured with high quality materials and components, which can be recycled and reused. [. . . ] To turn the amplifier up, rotate the gain control knob towards the max position. 2 To turn the amplifier up, rotate the gain control knob towards the max position. 3 Tilt or swivel the UHF antenna towards the transmitter until the reception is achieved. 3 Turn the TV or FM radio to the desired channel/station. Move the dipoles in different directions up and down until the reception is achieved. Note · It is possible to turn the gain control knob down for best reception. EN 7 English 4 Set up SDV5121 Note Set up a digital tuner with this antenna You can install available channels with the digital TV tuner. This automatic process is part of the setup of the tuner. Ensure the antenna has set up properly before the tuner can receive viewable channels. There are two ways to connect the antenna to the TV: · Connect the antenna to a digital tuner. If the signal strength is good enough, the channels can be memorized in the tuner automatically . Tune to the analogue channels and find the best antenna location. Then reconnect the antenna to the digital tuner. Ensure the signal strength is good enough before you install the channels with the tuner. Yes, there is a DC power socket located at the back of the antenna. Plug your cable/adapter into the antenna and then into your power source. Where should I place the antenna in order to get the best reception possible?Choose a location near a window which gives the antenna a clear view of the transmitter. Note · For best reception, place the antenna away from the metal surface to avoid interference. · How do I know how much gain (amplification) is required to receive a clear picture?Once you have the VHF dipoles extended to the longest length, turn on the amplifier. Turn the amplifier up to the max position and then reduce as needed. [. . . ] philips. com/welcome For technical support, send us an email with the model number of the product and a detailed description of your problem to:accessorysupport@philips. com 8 EN A Amplifier A device, either a single stage or a large scale circuit with multiple stages for creating gain, i. e. Antenna A device, such as a rod or wire, which picks up a received radio frequency signal or radiates a transmitted RF signal. HDTV (High-Definition Television) It is a digital television broadcasting system with higher resolution than traditional television systems (standard-definition TV, or SDTV). HDTV is digitally broadcast; the earliest implementations used analog broadcasting, but today digital television (DTV) signals are used, requiring less bandwidth due to digital video compression. U UHF (Ultra high frequency) In radio or TV broadcasting: it is the frequency range of electromagnetic waves which lies between 300 MHz and 3 GHz (3000 MHz). C Coaxial A single copper conductor, surrounded with a layer of insulation, covered by a surrounding copper shield and finally, an insulating jacket. [. . . ]