User manual PHILIPS SDV7220

[. . . ] · To completely disconnect the power input, the main plug of the product shall be disconnected from the mains outlet. · Where the main plug is used as the disconnect device, the disconnect device shall remain readily operable. [. . . ] Connectoneendoftheamplifiercoaxial cable to the TV receiver. 6 EN 4 Set up the SDV7220/12 Set up on the table 1 The antenna can be used with or without the included stand as below. 1 Unwrap the stand from the tablet of antenna. 2 Position the stand to the notches of the antenna. 3 Slidethestandtofixitontheantenna. 2 Slide the gain control switch of the amplifiertowardsthemax. position. 14 Tip · To disassemble the stand, reverse the assembly procedure. Note · It is possible to slide the gain control switch towards themin. positionorremovetheamplifierforbest reception. EN 7 English Assemble antenna and stand Mount on the wall 1 Mount two wood screws into the wall with 80mm (3. 149") of center distance. Tip · It is possible to slide the gain control switch towards themin. positionorremovetheamplifierforbest reception. Set up a digital tuner with this antenna 2 Plug the plastic bracket into two notches on the rear housing, then push it up to lock in. b You can install available channels with the digital TV tuner. This automatic process is part of the setup of the tuner. Ensure the antenna has set up properly before the tuner can receive viewable channels. There are two ways to connect the antenna to the TV: · Connect the antenna to a digital tuner. If the signal strength is good enough, the channels can be memorized in the tuner automatically . · Connect the antenna directly to the TV. Tunetotheanaloguechannelsandfind the best antenna location. Then re-connect the antenna to the digital tuner. Ensure the signal strength is good enough before you install the channels with the tuner. a 3 a Attach the plastic bracket to the wood screws on the wall. b 4 Slide the gain control switch of the amplifiertowardsthemax. position. 14 8 EN 5 Frequently asked questions Can this antenna work with Analogue transmissions?Yes, this antenna can receive analogue television broadcasts in the UHF bandwidths. Can this antenna receive digital or work with ATSC broadcasts?Yes, this antenna is designed to receive ATSC and HDTV broadcasts in the UHF bandwidths. [. . . ] Antenna A device, such as a rod or wire, which picks up a received radio frequency signal or radiates a transmitted RF signal. implementations used analog broadcasting, but today digital television (DTV) signals are used, requiring less bandwidth due to digital video compression. M Male connector A male connector is a connector attached to a wire, cable, or piece of hardware, having one or more exposed, unshielded electrical terminals, and constructed in such a way that it can be inserted snugly into a receptacle (female connector) to ensure a reliable physical and electrical connection . C Coaxial A single copper conductor, surrounded with a layer of insulation, covered by a surrounding coppershieldandfinally, aninsulatingjacket. An unbalanced transmission line with constant impedance. [. . . ]