User manual PHILIPS SERIE 5000

[. . . ] € Important Read this user manual carefully before you use the shaver, the Jet Clean System (PT927CC/PT923CC only) and the charging stand (PT927/ PT925/PT923/PT920/PT876/PT875 only). Save the user manual for future reference. Do not cut off the adapter to replace it with another plug, as this causes a hazardous situation. -- The shaver and the Jet Clean System are not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of these appliances by a person responsible for their safety. [. . . ] Each shaving head consists of a cutter and a guard. 13 Note: Do not clean more than one cutter and guard at a time, since they are all matching sets. If you accidentally mix up the cutters and guards, it may take several weeks before optimal shaving performance is restored. -- Remove the cutter from the shaving guard and clean it with the brush. -- Clean the inside and outside of the shaving guard with the brush. 6 Put the shaving heads back into the shaving unit. Note: Make sure that the projections of the shaving heads fit exactly into the recesses. 7 Put the retaining frame back into the shaving unit (A)and turn the lock clockwise (B). 8 Insert the lug of the shaving unit into the slot in the top of the shaver. Note: If the shaving unit does not close smoothly, check if you have inserted the shaving heads properly and if the retaining frame is locked. 14 English Cleaning the shaving unit in the Jet Clean System (PT927CC/PT923CC only) The Jet Clean System cleans the shaving unit. , , After the cleaning program, the battery symbol on the Jet Clean System goes on to indicate that the shaver is being charged. Note: If you press the on/off button of the Jet Clean System during the cleaning program,  the program aborts and resets. In this case, the cleaning stops flashing and the shaver holder returns to its starting position. The shaver may still be wet and dirty, because the cleaning program has not been finished. Note: If you remove the adapter from the wall socket during the cleaning program, the program aborts. The shaver holder remains in its current position. When you put the adapter back into the wall socket,  the shaver holder moves to its highest position. Note:When the fluid level drops below the minimum level, the cleaning symbol and the ‘fluid low’ symbol start to flash with intervals and the shaver holder returns to its starting position Cleaning the Jet Clean System Empty the cleaning chamber and clean it thoroughly by rinsing it with hot tap water every 15 days if you use the Jet Clean System daily. Otherwise empty and clean the cleaning chamber at least once a month. 1 Clean the outside of the Jet Clean System with a moist cloth. Never immerse the Jet Clean System in water, nor rinse it under the tap. [. . . ] The Jet Clean System (PT927CC/ PT923CC only)  does not work when I press the on/off button. Water leaks from the shaver after cleaning. Refill the cleaning chamber with cleaning fluid up to the MAX level (see chapter ‘Cleaning and maintenance’). Place the shaver without protection cap in the Jet Clean System properly. [. . . ]