User manual PHILIPS SHB1300

[. . . ] With the Philips SHB1300 you can enjoy convenient hands-free communication with your Bluetooth enabled phone. This instruction manual will help you to get started quickly and achieve the best performance from your headset. To activate pairing mode press and hold the multi function button S1until the LED starts flashing red and green alternately. [. . . ] If prompted by your mobile phone whether to accept the connection with the headset please confirm in order to establish the Bluetooth link. Charging your headset Before you use your headset for the first time charge the battery for 6 hours for optimum battery capacity and lifetime. Using another charger may damage or destroy your headset! Plug the AC adapter into the power outlet and connect the charger cable to the headsets DC socket. The headset LED will flash red instead of green when the battery is low and you will hear a short beep every few minutes. Finish your call before re-charging as connecting the charger to the headset will put your headset in charging mode and could cut an ongoing the call. Once the battery has run out of power you cannot power the headset on unless the charger is connected. Pair your headset to your mobile phone Your Bluetooth headset must be paired to your mobile phone before using it for the first time with your phone. "Pairing" will establish a unique encrypted link between your mobile phone and your headset. Make sure the headset (HS) is turned off, charged and disconnected from the charging cable before you start pairing. Rejecting incoming calls (Available if supported by your mobile phone) To reject an incoming call, press the multi function button S1 and hold it until you hear a long beep tone, then release it. Adjusting speaker volume During a call: Press and release S2 to increase the speaker volume and Press and release S3 to decrease the speaker volume. A key tone will indicate any increase or decrease of the volume. A higher pitch signal tone will alert you when the volume level reaches its maximum or minimum. [. . . ] To adjust the neckband in size: Open the clip (S4) Move the slider (S5)up or downward on the earplug cable Fix your preferred length with the clip (S4) For optimal wearing comfort choose one of the three included rubber ear caps that best fits your ear and place it on the earplug. Enable Bluetooth on your mobile phone and turn the HS on. Your mobile phone may not support this feature. [. . . ]