User manual PHILIPS SHB1400

[. . . ] • You should use caution or temporarily discontinue use in potentially hazardous situations. • For your safety, avoid distractions from phone calls while in traffic or other potentially dangerous environments. When this crossed-out wheeled bin symbol is attached to a product it means that the product is covered by the European Directive 2002/96/EC. Please inform yourself about the local separate collection system for electrical and electronic products. [. . . ] The headset stores the last eight links in the memory. If you try to pair more than eight devices, the link for the earliest paired device is overwritten. 1 2 3 4 1 2 Ensure that the headset is charged and turned off. Ensure that the mobile phone is turned on and its Bluetooth feature is activated. Press until the LED starts flashing red and blue alternately. Do not stop pressing the button after seeing the blue LED only. »» The headset is in pairing mode, which lasts five minutes. For details, refer to the user manual of the mobile phone. 1 Remove the USB cap. A sample pairing is shown below. Under Bluetooth menu on the mobile phone, search for the headset. From the found devices, select Philips SHB1400. • Enter “ 0000 ” (4 zeros), if prompted to enter the pin code of the headset. On mobile phones using Bluetooth 2. 1+EDR or higher, you may not need to enter a pass code. 2 Plug the headset into a powered USB port on a PC or into a power adaptor with USB outlet. Settings Connectivity Settings Settings Connectivity Bluetooth Devices Found Add Bluetooth device Philips SHB1400 Enter Password Select Back Select Back Select Back »» When the pairing is successful, a long beep occurs and the LED on the headset starts to flash blue every 3 seconds. »» During charging, the LED turns red. The LED turns off when the headset is fully charged. Tip •• Typically, a full charge takes 2 hours. EN 7 English 5 Get started Pair the headset with your mobile phone 6 Fit your headset 1 Place the earbud in your ear and rotate the headset upwards or downwards until it fits your ear securely. Optional (with an earhook) For an extra-secure fit, you can attach the earhook: Push the ball joint between the earbud and the main body of the headset. Adjust the earhook for providing the best fit. 8 EN Connect the headset to a mobile phone 1 With the mobile phone turned on, press until the LED lights up, to turn on the headset. »» Once turned on, the headset reconnects automatically to the last device it was connected to. »» If the last connected device is not available, the headset tries to reconnect to the second to last device that was connected to the headset. If it cannot find this device, it will look for all previously paired devices in the order of last usage, until it finds a device to connect to. [. . . ] • Enable the Bluetooth feature on your mobile phone and turn on the mobile phone before you turn on the headset. Pairing does not work. The headset is not in pairing mode. • Follow the steps described in this user manual. • Ensure that you see the LED light flashes red and blue alternately before you release the button. [. . . ]