User manual PHILIPS SHB9001WT

[. . . ] One of Philips leading Business Principles is to take all necessary health and safety measures for our products, to comply with all applicable legal requirements and to stay well within the EMF standards applicable at the time of producing the products. Philips is committed to develop, produce and market products that cause no adverse health effects. Philips confirms that if its products are handled properly for their intended use, they are safe to use according to scientific evidence available today. Philips plays an active role in the development of international EMF and safety standards, enabling Philips to anticipate further developments in standardization for early integration in its products. 3 E N GLISH 1 Important 1. 2 Electric-, Magnetic-and ElectromagneticFields( EMF ) 1. 3 Generalmaintenance Toavoiddamageormalfunction: · Donotexposetheheadsettoexcessiveheat. [. . . ] Plug the USB charging cable into your computers USB socket and connect the charger cable to the headsets charging socket. Caution Finish your call before charging the headset, as connecting the headset for charging will cut an ongoing call. During recharging the LED indicator will show a red light. The LED will turn off once charging is complete. Typically a full charge will take fourhours. Youcanoperatetheheadsetduring charging. 8 Topairyourheadsetwithyour mobilephone Make sure the headset is charged, your mobile phone is turned on and its Bluetooth feature is enabled. Check your phones user guide to learn how to turn on Bluetooth on your phone. 1 2 With the headset turned off, press until the LED starts blinking red and blue alternately. The headset will remain in "pairing mode" for 5 minutes. Pairing typically involves a few simple steps outlined below, please check your phones user guide for details. 10:35 10:36 Settings Settings 10:37 Connectivity Connectivity Settings Bluetooth Devices Found Add Bluetooth device Philips SHB9001WT Enter Password **** 0000 Select Back Select Back Select Back Access a menu on your mobile phone typically called "Setup", "Settings", "Bluetooth" or "Connectivity". Select the option to discover or search for Bluetooth devices. After a few seconds your phone should indicate that it has found the "Philips SHB9001WT". 4 Upon selecting the "Philips SHB9001WT" on your mobile phone typically you will need to confirm the pairing and enter a passcode. Please enter the headsets passcode "0000" (four zeros). After successful pairing, the headset will connect tothemobilephone. Youwillhearalongbeep to confirm successful pairing and the headsets LED will change from flashing red/blue to periodically flashing blue every three seconds. 3 9 E N GLISH 7 Using your Bluetooth stereo headset 7. 1 Connectingtoyourmobilephone Turn on the headset by pressing until the LED lights up. Once turned on the headset will reconnect automatically to the last device it was connected with. If the last connected device is not available the headset tries to reconnect to the penultimate device that was connected to the headset. If you turn the mobile phone or its Bluetooth feature on after turning on the headset connect the headset from your mobile phones Bluetooth menu. 7. 2 Automaticpowersaving If your headset cannot find any Bluetooth device to connect to in range within five minutes it will automatically power down to save battery life. 7. 3 Operatingyourheadset To control the headset you tap, hold and double tap the headsets buttons. A "tap", "hold" and "double tap" differs in the duration and speed of the button press. 1 sec 10 The table below shows how to operate your headset: E N GLISH In order to: Enter pairing mode Turn headset on Do this: Press until the LED starts blinking red / blue alternately Press for 2 seconds Sound and LED indicator feedback Alternating red/blue flash ·3xredflash:batteryislow ·2xredflash:>25%of charge remaining. ·1xblueflash:>50%of charge remaining. 4 sec Tap Hold Tap or Hold and simultaneously for 4 sec. Adjustvolume Tap VOL- or VOL+ Pick up a call / End a call Tap Pick up a 2nd call / put other call Tap on hold / switch back* Rejectacall Hold Redial the last number Double tap Activate voice dialing* Hold until "beep" sound Mute Mic Double tap (during call) Transfer call to phone* Other status indicators: Connected to Bluetooth device (while in standby or while listening to music) Ready for pairing On but not connected In call Low battery Hold Blue light flashes every 3 seconds. Turn headset off Play / Pause music Stop music Skip Fwd/Bwd FullSound One short beep: On Two short beeps: Off One long beep Two short beeps One short beep Short beep every five seconds until mute is turned off. One short beep In pairing mode, LED light flashes continuously alternating red and blue. While call is ringing, blue light flashes fast (twice per second). [. . . ] TrademarksarethepropertyofKoninklijke Philips Electronics N. V. or their respective owners. Philips Consumer Lifestyle AQ95-56F-992KR/2n d . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . / Numéro du Rapport) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . (Year in which the CE mark is affixed / Année au cours de laquelle le marquage CE a été apposé) 2008 EC DECLARATION OF CONFORMITY (DECLARATION DE CONFORMITE CE) We / Nous, PHILIPS CONSUMER LIFESTYLE B. V. (Name / Nom de l'entreprise) TUSSENDIEPEN 4, 9206 AD DRACHTEN, THE NETHERLANDS (address / adresse) Declare under our responsibility that the electrical product(s): (Déclarons sous notre propre responsabilité que le(s) produit(s) électrique(s):) PHILIPS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . (brand name, nom de la marque) SHB9000/00, /05, /10 SHB9001/00, /05, /10 SHB9001XX/00, /05, /10 (XX = any alphabetical for different color) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . (Type version or model, référence ou modèle) _ . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]