User manual PHILIPS SHC8680

[. . . ] Do not use cleansing agents containing alcohol, spirits, ammonia or abrasives as they may harm the housing. Use a slightly dampened chamois cloth to clean the housing. If fluid spills into the headphone system, remove the batteries immediately and consult an authorized dealer. Do not use this product in damp places or close to water. [. . . ] This product complies with the latest safety regulations. Please only charge the battery with the docking station provided (SHC8680) or with fully compatible charger. Adjust the volume level of the audio source to a fixed reasonably high level; for example 25% of the maximum level. In case of certain TVs, the headphone jack output level can only be adjusted after accessing the TV on-screen menu. Check if the white RCA plug (left channel) is connected to the left channel (white) of the audio source. In case the audio source has an adjustable RCA output level, adjust the output level to the highest acceptable undistorted level. 15 Plug the bypacked in ear headphone (SHE775WN/00) into the HEADPHONE OUTPUT jack ( ) of the receiver unit. 16 Depending on your preferred wearing style, you may carry the receiver unit with the provided neckstrap or belt clip. 17 Select one of the three transmission channels provided at the back of the transmitter station. We recommend you to select channel one as your first option. 18 Switch on your audio source and carefully increase the volume of the audio source. The POWER INDICATION on front of the transmitter station will be illuminated in red when signals are received. 19 Switch on the POWER of the receiver unit. The POWER STATUS light on the receiver unit will be illuminated in red automatically. 20 Press and hold the AUTO TUNING button on the receiver unit for about 1 second to tune to the correct transmission channel. 21 In case interference from neighbouring transmitters has occurred, adjust the transmission channel of the transmitter station, then repeat step 20 to tune the receiver unit. 22 Adjust the volume to your desired listening level. Avoid adjusting the listening volume level at the audio source as this may compromise the audio quality on too low input levels. 23 To enjoy sound enhancement features, you may choose between the following 2 options: ­ Bass boost ­ Treble boost 24 You may adjust the balance between left and right channels of the headphone according to your personal preference. 25 For certain TV broadcast where Nicam Language selection is available, you may choose your preferred language by playing: ­ Stereo ­ only the left channel ­ only the right channel 26 When battery is running low, the POWER STATUS light will flash for approximately 1 minute, reminding you to recharge the receiver unit. At the same time, the receiver unit will be muted automatically to avoid poor sound quality. If a fault occurs, first check the points listed below. [. . . ] Push and hold the AUTO-TUNING button for about 1 sec, then the receiver unit will automatically search for the best possible reception. We advise you to select channel 1 as the first option. Receiver unit too far away from transmitter Transmitter other than SHC8680 is used Move closer for reception Make use of the SHC8680 transmitter provided. Some transmitters already built into other equipment may not be compatible with the SHC86880 receiver unit because of the advanced technologies used. [. . . ]