User manual PHILIPS SLE3100EN

[. . . ] When you have other brands, you simply define the brands of your devices when you use ProntoNEO for the first time. See `Defining the Brands of Your Devices' on p. ProntoNEO can also learn IR codes from your existing remote controls. ProntoNEO can receive and store the IR codes by means of its learning eye. [. . . ] The following information is displayed on this screen: · Free memory (in percentage), which gives you an indication on how much memory is left to (further) customize the ProntoNEO; · Boot version; · Application version; · Configuration file. Revert Warning When you revert the ProntoNEO, all customization is lost permanently. You loose all ProntoNEO settings, defined brands, learned codes and recorded macros. By tapping the Revert button the ProntoNEO will be reverted to the default configuration. Reverting to the original configuration restores the ProntoNEO to its initial state. You might have to revert when you notice that scrolling through pages is slowing down. This might be the case when you have added a lot of commands to the ProntoNEO. A message screen appears to confirm or cancel the revert process. 2 Press OK or Cancel. To exit Setup Mode 1 Press the Mode button. 2 Tap the mode button you want to go to. See also `Working with Modes' on p. 10. User Manual 14 Using ProntoNEO Defining the Brands of Your Devices Like other remote controls ProntoNEO uses infrared (IR) codes to activate devices. The ProntoNEO is set by default to operate Philips devices. TV, with the buttons you want to program as a macro. The device screen appears. Note Basically, you can assign any button as a macro button. However, it is recommended to assign only the reserved macro buttons on the last page of every device. Use the Page Up and Page Down buttons to go to the last page of the device. 3 Press and hold the Mode button for 3 seconds. ProntoNEO is now in Macro Mode. 5 Tap Next. The device screen with the Macro label appears. With the Page Up and Page Down buttons you can go to other screens of the selected device. User Manual 21 Using ProntoNEO 6 Tap the soft or hard button you want to select as a macro. A message screen appears. 7 Tap Start. The Device Overview appears with the `Recording' label at the top of the screen. The buttons you tap on this screen will not be recorded. From the Device Overview you can go to the different devices or you can press the Extra hard button to go to the Extra screen with delays and beeps. 8 Tap the button of the device you want to go to. [. . . ] · Check if the battery level is low. · Check if there is sufficient memory to learn commands. See `ProntoNEO Information' and `Revert' on p. 14. User Manual 29 Troubleshooting ProntoNEO is not recognized by the NEOedit software · Make sure the serial cable is properly connected. [. . . ]