User manual PHILIPS SNB6500

[. . . ] SNB6500 EN User manual 3 Helpline België/Belgique/Belgien 070 253 010 (. 0. 20) Luxemburg/Luxembourg 26 84 30 00 Norge 2270 8250 Danmark 3525 8761 Österreich 01 546 575 603 (low rate) Deutschland 0180 5 007 532 (. 0. 12) Portugal 2 1359 1440 España 902 888 785 (. 0. 15) Schweiz/Suisse/Svizzera 02 2310 2116 France 08 9165 0006 (. [. . . ] Then click `Browse. . . ' to look for the downloaded file. Check the Status page Information section to confirm that the upgrade process was successful. Reset Click `REBOOT ROUTER' to reset the Wireless Router. If you perform a reset from this page, the configurations will not be changed back to the factory default settings. Note: If you use the Reset button on the rear panel, the Wireless Router performs a power reset. Press the button for over five seconds, and the factory default settings will be restored. System Time Settings Select your local time zone from the drop down list. This information is used for log entries and client filtering. For accurate timing of log entries and system events, you need to set the time zone. Select your time zone from the drop down list. If you want to automatically synchronize the Wireless Router with a public time server, check the box to Enable Automatic Time Server Maintenance. Select the desired servers from the drop down menu. Password Settings Use this page to change the password for accessing the management interface of the Wireless Router. Passwords can contain from 3~12 alphanumeric characters and are case sensitive. Note: If you lost the password, or you cannot gain access to the user interface, press the reset button on the rear panel, holding it down for at least five seconds to restore the factory defaults. By default, there is no password to login to the user interface. 32 EN WARNING!When you reset the Wireless Router using the blue reset button all configuration settings will be lost, also your ISP settings. Enter a maximum Idle Time Out (in minutes) to define a maximum period of time for which the login session is maintained during inactivity. If the connection is inactive for longer than the maximum idle time, it will perform system logout, and you have to log in again to access the management interface. (Default: 10 minutes) Remote Management By default, management access is only available to users on your local network. However, you can also manage the Wireless Router from a remote host by entering the IP address of a remote computer on this screen. Check the Enabled check box, and enter the IP address of the Host Address and click `SAVE SETTINGS'. Note: If you check Enable and specify an IP address of 0. 0. 0. 0, any remote host can manage the Wireless Router. For remote management via WAN IP address you need to connect using port 8080. Simply enter WAN IP address followed by :8080, for example, 212. 120. 68. 20:8080. SNMP Use the SNMP configuration screen to display and modify parameters for the Simple Network Management Protocol (SNMP). [. . . ] Your Home Connect home network gateway is compliant with HPNA Specification 2. 0, which allows networking speeds of up to 1 million bits per second (Mbps) using your existing home phone lines. An IP address consists of a series of four numbers separated by periods, that identifies an single, unique Internet computer host. The ISP Gateway Address is an IP address for the Internet router located at the ISP's office. This address is required only when using a cable or DSL modem. [. . . ]