User manual PHILIPS SPB4230WA

[. . . ] Uninterruptible Power System (UPS) SPB4230WA Register your product and get support at www. philips. com/welcome EN User Guide 3 Table of contents 1 2 2. 1 2. 2 2. 2 3 3. 1 3. 2 3. 3 3. 4 4 5. Important Your UPS What's in the box What you'll also need UPS overview Getting started Connect your UPS Connect your UPS to a phone/fax/modem Connect your UPS to a TV/VCR/DVDR/cable box Check the power requirement of your equipment Using your UPS Using more of your UPS Storage Warranty and service Technical data Frequently asked questions 4 4 5 5 6 7 7 8 8 9 9 11 12 13 16 17 3 1 Important Take time to read this manual before you use your UPS. It contains important information and notes regarding operating and maintaining your UPS and batteries. © 2007 Koninklijke Philips Electronics N. V. Reproduction in whole or in part is prohibited without the written consent of the copyright owner. [. . . ] Restore power to UPS by plug the power cord back into the wall outlet. Repeat this simulation test a few times to confirm your UPS is working properly and determine the expected runtime. Note If a power failure occurs immediately after you turn on the UPS, but before its initial self-test sequence, your UPS will automatically shut down. It will not restart until electrical power is restored. This allows your UPS to check the quality of the power that is delivered to your connected equipment. Tip To maintain a full battery charge, leave your UPS plugged in and turned on at all times. The surge protection of your UPS has a limited life. Even under normal circumstances, and in the absence of defects, this surge protection will end when the components providing protection exceed capacity and cease to provide protection from power surges and spikes. These surge protection components feature an internal protection that will disconnect them at the end of their useful life, but will still maintain power to your connected equipment (load). When this occurs, you will have to replace your UPS to restore protection to your connected equipment. 2 Wait for the power indicator to 3 Unplug the UPS power cord from the wall. When an electrical power failure occurs, the battery power outlets of your UPS will supply power to the connected equipment from its battery. An alarm will beep once every two seconds. Confirm all equipment connected to the battery power outlets of your UPS is operating under the limited rating power. 10 illuminate. Your UPS is equipped with an LED indicator display to keep you alert to its effectiveness. This surge protection indicator light is illuminated when the surge protection components are functioning properly. If this light is off, it indicates that the surge protection components have reached capacity and are no longer able to protect your connected equipment against surges. Your UPS also offers a "ground" indicator light to confirm that the wall outlet is wired properly. safe to channel to your equipment. Once the power returns, the UPS will automatically reset itself to normal operation and recharge its internal battery. Back-up alarm In the event of a power failure, your UPS will sound an alarm, alerting you that it is going into back-up mode. It will sustain this alarm, beeping slowly every two seconds. To mute the alarm: 1. Press the power button for one second and release. Warning Do not hold the power button down for more than 1 second when muting the alarm. [. . . ] When you contact Philips, make sure that your UPS is nearby and the model number and serial number are available. What should I do if I cannot turn the UPS on or the LED light will not illuminate?This may occur if the battery voltage is less than 10V. Recharge the UPS for a minimum of six hours. [. . . ]