User manual PHILIPS SQM5222

[. . . ] Phillips head screw driver Ratchet or driver with 7 mm socket Electric drill 1/4" (6 mm) drill bit for drywall installation 12 mm masonry bit for concrete installation In this chapter, the basic steps to get you started are described. Using a stud finder, locate and mark two adjacent studs for securing the mount (make sure your marks are in the center of each stud). You can use your own stud finder or the one included in the hardware kit. Using the enclosed mounting template, place the diagram against the wall and mark four locations (two per stud) on the wall where the mount is to be installed. [. . . ] With the help of another person, place the mount against the wall and level it using the bubble guide. While another person holds the mount in place, mark four locations (two per stud) on the wall where the mount is to be installed. (these marks should line up with the ones made in step 3 above using the template). set the mount aside and drill a 1/4" (6 mm) pilot hole at each marked location. Place the mount back against the wall and secure it using the lag bolts (Q) and lag bolt washers (R) provided. Do not over-tighten these bolts and do not release the mount until all bolts are in place. Once all (4) lag bolts are in place you must tighten each one. Using the enclosed mounting template, place the diagram against the wall and mark four locations on the wall where the mount is to be Installed. With the help of another person, place the mount against the wall and level it using the bubble guide. While another person holds the mount in place, mark four locations on the wall where the mount is to be installed. Move the safety tab located on each arm into position to avoid having the display accidentally lifted from the mount. This MUST be done in order to secure the display to the mount. The cable management clips can be used to keep your power cord and other cables in order. Side-to-side and front-to-back adjustments can be made by firmly grasping your display and carefully moving it to the desired position. If any of the arms become too lose to hold their position, they can be tightened using the alley key provided in your hardware kit. Please contact Philips directly if you have any questions in the installation process of the wall mount. Limited Two-Year Warranty Philips warrants that this product shall be free from defects in material, workmanship and assembly, under normal use, in accordance with the specications and warnings, for two years from the date of your purchase of this product. This warranty extends only to the original purchaser of the product, and is not transferable. To exercise your rights under this warranty, you must provide proof of purchase in the form of an original sales receipt that shows the product name and the date of purchase. For customer support or to obtain warranty service, please call 919-573-7854. [. . . ] To exercise your rights under this warranty, you must provide proof of purchase in the form of an original sales receipt that shows the product name and the date of purchase. For customer support or to obtain warranty service, please call 919-573-7854. Incidental, special and consequential damages are disclaimed where permitted by law. This warranty gives you specic legal rights. [. . . ]