User manual PHILIPS SQM5312

[. . . ] ⷠFollow all instructions and recommendations regarding adequate ventilation and suitable locations for mounting your display. Consult the owner's manual for your display for more information. ⷠThis mount is equipped with a safety device that must be used whenever the mount holds a display. Not using the safety device can cause property damage, serious injury, or death. [. . . ] IncludesEasy1-2-3 installation kit, complete with: all necessary hardware for mounting on different types of walls, mountingtemplates, studfinderand bubblelevel. In this chapter, the basic steps to get you started are described. Carefully read the safety precautions in "Section 1 Important" before you install the wall mount. For safety reasons, this mount must be secured to two adjacent wood studs at least 16" apart. The studs must be capable of supporting the combined weight of the mount and display. see enclosed mounting template for diagram and guide of how to mount properly on the wall. U 2 singastudfinder, locateandmarktwo adjacentstudsforsecuringthemount (make sure your marks are in the center of each stud). You can use your own stud finder or the one included in the hardware kit. Singtheenclosedmountingtemplate, U place the diagram against the wall and mark four locations (two per stud) on the wall where the mount Is to be Installed. 4 With the help of another person, place the mount against the wall and level it using the bubble guide. If the back of your display is curved or recessed: You will be using one of the longer bolts and a spacer. If the concrete wall is covered by a layer of plaster or drywall, the concrete anchor must pass completely through the layer to rest flush with the concrete surface. Determine the correct diameter bolt to use by trying one bolt each from Bags 1-4ofthehardwarekit. Donotforceany of the bolts ­ if you feel resistance stop immediately to avoid damaging your display. Attach the arms to the back of your display using the bolts identified in Steps 1 and 2 and the corresponding lock washer (C, F, I, orL). youwillneedtousetheM6 washers(O)ifyouareusingtheM4 , M5 , or M6 bolts. If your display has a curved or recessed back, you may also need to use a spacer(MorN). Make sure the screws are snug, but do not over-tighten. With the help of another person, carefully lift your display and place it on the wall plate. Do not release the display until the mounting arms have securely hooked onto the mount. [. . . ] Carefully hook the display onto the wall plate. Use a longer bolt and spacer for displays with curved or recessed backs. Do not use the M6 washer (O) if you are using the M8 bolts (J or K). Insert the safety bar at the bottom of the mount to avoid having the display accidentally knocked off the mount. [. . . ]