User manual PHILIPS SQM5822

[. . . ] If you are unsure of your wall composition or for assistance with other surfaces, contact a qualified installer. · The wall or mounting surface must be capable of supporting the combined weight of the mount and the display; otherwise the structure must be reinforced. · Do not exceed the maximum load capacity of 132lbs for this product. [. . . ] 1 1 1 2 See enclosed mounting template for diagram and guide of how to mount properly on the wall. Using a stud finder, locate and mark two adjacent studs for securing the mount (make sure your marks are in the center of each stud). Once studs have been located you will need to verify with a hammer and a nail A) Simply place the nail over your mark on the wall and tap in with hammer. if the nail encounters resistance and is secure in wall you have verified a stud location B) If it just pushes through with no resistance you will need to start over and locate the stud. Using the enclosed mounting template, place the diagram against the wall and mark four locations (two per stud) on the wall where the mount Is to be Installed. Be sure to use the center of each stud. D Note 3. 2 Mounting the wall plate (concrete) B Warning For safety reasons, the concrete wall must be capable of supporting the combined weight of the mount and display. 1 2 3 See enclosed mounting template for diagram and use enclosed mounting template as a guide for precision mounting. Using the enclosed mounting template, place the diagram against the wall and mark six locations on the wall where the mount Is to be Installed. 5 3 4 5 6 7 With the help of another person, place the mount against the wall and level it using the bubble guide. While another person holds the mount in place, mark six locations on the wall where the mount is to be installed. Set the mount aside and drill a 3/8" (10 mm) pilot hole at each marked location. Insert a concrete anchor (P) into each hole so that it is flush with the concrete surface. A hammer can be used to lightly tap the anchors into place if necessary. Place the mount back against the wall and secure it using the lag bolts (Q) and lag bolt washers (R) provided. Do not over-tighten these bolts and do not release the mount until all bolts are in place. 2 2 3. 3 Attaching the arms to the display B Warning Use extra care during this part of the installation. Avoid laying your display face down if possible as it may damage the viewing surface. 1 Examine the back of your television. [. . . ] For customer support or to obtain warranty service, please call 1-919-573-7854. THERE ARE NO OTHER EXPRESS OR IMPLIED WARRANTIES. Philips' liability is limited to repair or, at its sole option, replacement of the product. [. . . ]