User manual PHILIPS SQM6375

[. . . ] Register your product and get support at This product is designed strictly for installation on a vertical wall in commercial and residential buildings. it is constructed of wooden wall studs (40cm (16") or 60cm (24") pitch) , masonry (brick or stone) or solid concrete only. [. . . ] This product is not designed for installation on walls constructed of metal studs or studs with a pitch exceeding 60cm (24"). If you are unsure of your wall composition, contact a qualified installer. To avoid weakening the wall strength, drill at least 2. 5cm (1") away from another drill hole. If the wall mount bracket is not perfectly level, adjust the angle of the display later, as described in the wall mount guide (section 3, image b). the roller mechanism is designed for a perfect leveling during installation. Avoid frequent moving of the rollers inside the rail as this can unscrew the rollers and cause damage to the rollers and the display. The wall or mounting surface must be capable of supporting the combined weight of the mount and the display; otherwise the structure must be reinforced. Safety gear and proper tools must be used. Failure to do so can result in property damage and/or serious injury. A minimum of two people are required for this installation. Do not attempt to install this mount alone under any circumstance. The wall mount allows a limited tilting movement if you pull on the bottom edge of the display. However, for inserting and adjusting cables and connectors, we strongly advise you to dismount the display. [. . . ] Om du vill ha teknisk support kan du skicka e-post till oss. Specifications are subject to change without notice Trademarks are the property of Koninklijke Philips Electronics N. [. . . ]