User manual PHILIPS SRC3036

[. . . ] 13 Setting any Mode to use its own Volume/Mute 13 TV/VCR/INPUT . Philips Universal Remotes let you replace a broken or lost remote or combine more than one remote into one. This remote control operates the common features of most but not all models and brands of IR Infrared Controlled Video Equipment. This remote may provide functions that are not available on your equipment. [. . . ] On the back of the remote, push down on the tab and lift the cover off. Match the batteries to the + and - marks inside the battery case, then insert 2 AAA Alkaline batteries. Your remote automatically turns off if the buttons are depressed more than 30 seconds. This will save your batteries should your remote get stuck in a place where the buttons remain depressed (e. Codes are stored in permanent memory while you are changing batteries so you will not lose any codes stored in the remote while you are changing batteries. CHANNEL + and CHANNEL - buttons perform the "Page+" and "Page-" function for on-screen Guide Menus used by some Satellite systems. iNFO/SELECT button brings up Satellite Display screen for current Channel and system information. MENU brings up the Satellite Menu screen - use with the UP, DOWN, LEFT & RIGHT navigation buttons. You can either setup the remote using the code for your brand of product, from the code tables (on separate sheet), or you can search through the library of codes until you find a code that works for your product. Please refer to "Programming with Code Search" on page 8 for more information on using the code search feature to learn how to search through the library of codes for your products. NOTE: You can store any kind of code under any mode (except TV). However, you can only store TV codes under the TV button. Press and hold the SETUP button until the red indicator stays on, then release the SETUP button. Enter the 4 digit code from the code tables (on separate sheet). Note: after a valid code entry, the red indicator turns off. Note: If some buttons do not operate your equipment, try one of the other codes for your brand. Write your codes down here for easy reference later. If (for example) you want to store a VCR code under CABLE, first follow the procedure for Direct Code Entry (previous page) and press CABLE in step 2 of Direct Code Entry, then enter ANY VCR code in step 3 of Direct Code Entry. Then follow the steps above for Code Search (or Brand Search, below). Note: If the device does not have a CHANNEL UP button, use PLAY (VCR only) or POWER instead. Code Search starts from the currently stored 4 digit number under that mode. Lets you search for a code for a specific Brand within the Code Library for a particular manufacturer. [. . . ] Point both remotes facing each other by approximately 1 inch apart (see tips on page 14). Power) until the red indicator blinks once and stays on. If there is a learning problem, the indicator blinks for three seconds and stays on. Repeat Steps 4-6 for other buttons you want to learn. [. . . ]