User manual PHILIPS SRU 5086

[. . . ] Check whether all the keys are working For an overview of the keys and their functions see `3. If the TV responds as it should to all of the key commands the SRU 5010 is ready for use. If the TV does not respond at all or not to all of the key commands, follow the instructions under `Setting the remote control', or for online setup go to: www. This is only necessary if your TV does not respond to the SRU 5010. [. . . ] If the LED flashes once for an extended period, the code has not been entered properly or the wrong code has been entered. If the TV responds to all of the key commands, the SRU 5010 is ready for use. If the TV does not respond at all, or not to all of the key commands, start again from step 2 and try the next code from the list. The illustration on page 3 gives an overview of all keys and their functions. Switches between external inputs of your equipment. Direct choice of channels and other functions. When pressed at the same time as a second key, the second key will get another function. All blue labelled keys can be used together with SHIFT. Stores TV settings Try out other combinations with the SHIFT-key on your TV in order to find out which functions are available. Only functions featured on the original remote control are available. 0 Red, green, yellow and blue teletext keys !Jumps back one level in the menu or turns off the menu. ^ LED · If the device does not respond at all, or not to all of the key commands, follow the instructions under `Setting the remote control'. It is possible that you must enter another code for the device. If you want to add a function to the SRU 5010, you can contact the Philips service line for Universal Remote Control to ask for the 5-figure code for the extra function. Restoring the original functions of your remote control 1 Keep keys 1 and 6 on the SRU 5010 Pressed simultaneously for three seconds, until the LED flashes twice and then remains lit. Press keys 9, 8 and 1, in that order The LED flashes twice. All original functions have now been restored and any extra functions have been deleted. ­ Problem Solution The LED blinks four times after every key press. The remote control is indicating that its batteries are running low. Replace the old batteries with two new 1. The TV does not respond and the LED does not flash when you press a key. [. . . ] Look up the numbers of the models in the instructions accompanying the device or on the back of your device. When you call our helpline, make sure the device is to hand so that our operators can help you determine whether your remote control is working properly. The model number of your Philips universal remote control is SRU 5010/86. Om du vill lägga till en funktion till SRU 5010, kan du ringa Philips kundtjånsten för universalfjärrkontroller och be om den 5-siffriga koden för extrafunktionen. [. . . ]