User manual PHILIPS SRU 7060 10

[. . . ] If that is the case, the SRU 7060 10 does not recognize the brand and/or model of your device and you need to program the remote control to do so. The example below (TV) instructs you how to do this. You can repeat the same steps for other devices (DVD player/recorder, VCR and set-top box) which you want to operate using the SRU 7060 10. You can set the remote control either manually or automatically. [. . . ] One or more four-figure codes are shown for each brand. Com/urc you can directly select your device typenumber to find the right code. Make sure you use the codes from the correct table. Select TV: keep the TV key pressed for 5 seconds until it blinks twice and then remains lit. Then enter the code noted in step 2, using the digil keys. If the key blinks once for an extended period, the code has not been entered properly or the wrong code has been entered. If the TV responds to all of the key commands, the SRU 7060 10 is ready for use. If the device does not respond at all, or not to all of the key commands, start again from step 2 and try the next code from the list. Automatically setting the remote control The remote control will now automatically search for the right code for your device. Example of TV: 1 Make sure the TV is switched on and select a channel using the original remote control or the keys on the TV (for example channel 1). 2 Select TV: keep the TV key pressed for 5 seconds until it blinks twice and then remains lit. The SRU 7060 10 is default set for operating TV, STB, VCR or DVD You can select the device you wish to operate with the TV, STB, VCR and DVD keys. each key allows operation of one device only. If desired, you can program the keys to select a different kind of device. For example, if you want to operate a second TV. In the following example you will see how to configure the DVD key for a second TV. Select DVD: keep the DVD key pressed for 5 seconds until it blinks twice and then remains lit. Then keep keys 1 and 6 on the SRU 7060 10 pressed simultaneously for 5 seconds, until the DVD key lights up. Select TV: keep the TV key pressed for 5 seconds until it blinks twice and then remains lit. The DVD key will now allow you to operate your second TV. Restoring the original functions of your remote control 1 Keep keys 1 and 6 on the SRU 7060 10 pressed Simultaneously for 5 seconds, until the key of the currently selected mode (TV, STB, VCR or DVD) blinks twice and then remains lit. The SRU 7060 10 is now reverted back to the state it was when you first took it out of the packaging. [. . . ] ­ Problem Solution The device you want to operate does not respond and the mode key (TV, STB, VCR or DVD) does not blink when you press a key. Replace the old batteries with two new AAA batteries. The device you want to operate does not respond but the mode key (TV, STB, VCR or DVD) does blink when a key is pressed. Point the SRU 7060 10 at the device and make sure that there are no obstructions between the SRU 7060 10 and the device. [. . . ]