User manual PHILIPS SRU 7140

[. . . ] - switches between external (audio / video) inputs of your equipment (TV, STB). Selects between one- and twofigure channel numbers (TV, STB). For some brands, press once, then press again for three seconds. - jumps back one level in the menu or turns off the menu (TV, STB, DVD). [. . . ] If you accidentally go past the code required, press PROG - to go back until the device responds. Programming with Brand Search Allows you to search for a code for a specific brand in the code library for a particular manufacturer. Press and hold SETUP until the device mode indicator blinks and then remains lit, then release the key. Press and release PROG + (or 2 (in case of VCR) or ) repeatedly until the device responds. The device mode indicator turns off with each command sent. If you accidentally go past the code required, press PROG - to go back until the device responds. ) require you to set up two different source selection keys to control both parts of the combo device. For example, if you have a TV/DVD combo, you might need to set up one code under the TV key to control the TV and a separate code under the DVD key to control the DVD. In most home entertainment systems, the volume is controlled by one device only (usually TV or amplifier). This means you always have to switch to TV or AMP mode to adjust the volume of any other device. The `Volume control punch through' feature enables you to set the remote control's VOL +/- and (Mute) keys to also adjust the sound of other devices in your system, even those that do not have a volume control of their own. 1 2 ­ 3 4 5 ­ ­ ­ · First decide which source selection key you wish to set up for volume control (e. Press and hold SETUP until the device mode indicator blinks and then remains lit, then release the key. Press and hold (Mute) until the device mode indicator blinks once, then release the key. All other devices will now punch-through to the selected source (AMP) for volume/mute control. The indicator blinks rapidly for 3 seconds if the source you have selected has no volume/mute control. Reset Volume/Mute control to factory default by repeating above sequence. If you miss certain functions from your original remote control, this remote control can learn these functions from the original remote control. tips on learning functions · Only one original remote type should be learned per individual mode. First clear all learned functions for a device mode (TV, DVD, STB or AMP) to make sure there are no previously learned functions for that mode. For this, refer to `Clearing all learned functions for a device mode'. Place the remote controls head-to-head so the IR transmission LED's on both remote controls are directly in line with each other. [. . . ] Try to program the code again or try a different code. Par exemple, si vous disposez d'un combiné téléviseur/lecteur de DVD, vous pouvez configurer un code sous la touche TV, pour commander le téléviseur, et un autre sous la touche DVD, pour commander le lecteur de DVD. Använd nya batterier till både fjärrkontrollen som funktionerna ska överföras till och den ursprungliga fjärrkontrollen. Upprepa steg 5 till 6 för andra funktioner från den valda enheten som du vill överföra till den nya fjärrkontrollen. [. . . ]