User manual PHILIPS SRU1018

[. . . ] You can find information about how to prepare this remote control for use in the chapter `Installing the remote control'. 2 Place two R03, UM4 or AAA type batteries into the battery compartment, 3 as shown. Replace the cover and click it firmly into place. Because the SRU 1018 may use different signals for each brand and even for different models of the same brand, it is advisable to test whether your TV responds to the SRU 1018. [. . . ] Make sure you use the codes from the correct table. Keep keys 1 and 3 on the SRU 1018 pressed simultaneously for five seconds until the indicator light remains lit. Then enter the code noted in step 2 using the code keys. The indicator light will now flash twice. If the indicator light flashes once for an extended period, the code has not been entered properly or the wrong code has been entered. If the TV responds to all of the key commands, the SRU 1018 is ready for use. If the device does not respond at all, or not to all of the key commands, start again from step 2 and try the next code from the list. Automatically setting the remote control If you cannot find the right code for your brand device, the remote control can automatically search for the right code. Make sure the TV is switched on and select a channel using the original remote control or the keys on the TV (for example channel 1). Keep keys 1 and 3 on the SRU 1018 pressed simultaneously for five seconds, until the indicator light remains lit. Press the y key of the SRU 1018 and keep it pressed. The SRU 1018 now starts emitting all known `TV off ' signals, one by one. Each time a code is sent, the indicator light flashes. When your TV switches off (stand-by), immediately release the y key of the SRU 1018 to confirm. The SRU 1018 has now found a code that works on your TV. Check if you can operate all functions on your TV with the SRU 1018. If this is not the case, you can redo the automatic setting. The SRU 1018 will then search for a code that perhaps works better. [. . . ] None of the codes works during manual setting of the remote control. Disposal of your old product Your product is designed and manufactured with high quality materials and components, which can be recycled and reused. When this crossed-out wheeled bin symbol is attached to a product, it means the product is covered by the European Directive 2002/96/EC. please inform yourself about the local separate collection system for electrical and electronic products. [. . . ]