User manual PHILIPS SRU1060

[. . . ] Because the SRU1060 may use different signals for each brand and even for different models of the same make, it is advisable to test whether your brand responds to the SRU1060. The example below (TV) instructs you how to do this. You can repeat the same steps for your DVD player/recorder which you want to operate using the SRU1060. Example of TV: 1 Turn your TV on manually or use the original remote control. [. . . ] The SRU1060 will then search for a code that works better. After the SRU1060 has run through all the known codes, the search will stop automatically and the LED stops flashing. Manually setting the remote control Example of TV: The keys between brackets are used for setting the SRU1060 for your DVD players/recorder. 2 Look up the code of your TV in the code list at the back of this manual. ENGLISH The code exists of a combination of 5 keys (always the cursor keys and the OK key in various combinations). One or more codes are shown for each brand. Com/urc you can directly select your device typenumber to find the right code. Make sure you use the codes from the correct table. Keep keys VOL + and PROG + (5 and 6) on the SRU1060 pressed simultaneously for three seconds until the LED flashes twice and then remains lit. Then enter the code noted in step 2 using the 1, 2, 3, 4 and OK keys. If the LED flashes once for an extended period, the code has not been entered properly or the wrong code has been entered. If the TV responds to all of the key commands, the SRU1060 is ready for use. If the device does not respond at all, or not to all of the key commands, start again from step 2 and try the next code from the list. The illustration on page 3 gives an overview of all keys and their functions. Switches between external inputs of your equipment. Jumps back one level in the menu or turns off the menu. general 1 LED · If the device does not respond at all, or not to all of the key commands, follow the instructions under `Setting the remote control'. It is possible that you must enter another code for the device. Keep keys DISC MENU and BACK on the SRU1060 pressed simultaneously for three seconds, until the LED flashes twice and then remains lit. All original functions have now been restored and any extra functions have been deleted. ­ Problem Solution The LED blinks four times after every key press. The remote control is indicating that its battery is running low. [. . . ] The model number of your Philips universal remote control is SRU1060. If the TV responds to all of the key commands, the SRU1060 is ready for use. Stille inn fjernkontrollen automatisk The remote control will now automatically search for the right code for your brand. 1 Varmista, että television on kytketty päälle ja valitse kanava alkuperäisen kauko-ohjaimen tai television painikkeiden avulla (esimerkiksi kanava 1). [. . . ]