User manual PHILIPS SRU3040

[. . . ] For an overview of the keys and their functions see `3. If the TV responds as it should to all of the key commands the SRU 3040 is ready for use. If the device does not respond at all or not to all of the key commands, follow the instructions under `Setting the remote control', or for online setup go to: www. [. . . ] When your TV switches off (stand-by), immediately release the Standby key of the SRU 3040. The SRU 3040 has now found a code that works on your TV. Check if you can operate all functions on your TV with the SRU 3040. If this is not the case, you can redo the automatic setting. The SRU 3040 will then search for a code that works better. After the SRU 3040 has run through all the known codes, the search will stop automatically and the TV key stops blinking. The illustration on page 3 gives an overview of all keys and their functions. Switches between normal operation mode and Easy brand scan mode (press with pen or paperclip). - pressed together with SHIFT 6: selects external Audio/Video inputs, connected to the SCART connector(s) of your equipment (A/V function). - pressed together with SHIFT 6: confirms your selection. STB: pressed together with SHIFT 6: confirms your selection. - jumps back one level in the menu or turns off the menu. - pressed together with SHIFT 6: cursor left, right in a menu. When pressed at the same time as a second key, the second key will get another function. Try out other combinations with the SHIFT-key on your device in order to find out which functions are available. Only functions featured on the original remote control are available. [. . . ] Try programming the SRU 3040 again using another code, which is mentioned under the brand of your device, or reset for automatic search to find the right code. Your brand of device is not in the code list. None of the codes works during manual setting of the remote control. [. . . ]