User manual PHILIPS SRU4010

[. . . ] Place two AAA type batteries into the battery compartment, as shown. Slide the cover back and click it firmly into place. Because the SRU 4010 may use different signals for each brand and even for different models of the same brand, it is advisable to test whether your TV responds to the SRU 4010. The example below instructs you how to do this. [. . . ] Then enter the code noted in step 2, using the digit keys. If the key blinks once for an extended period, the code has not been entered properly or the wrong code has been entered. If the TV responds to all of the key commands, the SRU 4010 is ready for use. If the device does not respond at all, or not to all of the key commands, start again from step 2 and try the next code from the list. Automatically setting the remote control The remote control will now automatically search for the right code for your device. Make sure the TV is switched on and select a channel using the original remote control or the keys on the TV (for example channel 1). Use a pen or paper clip to press the Setup key and keep it pressed for 5 seconds until the Standby key blinks twice and then remains lit. Press the Standby key of the SRU 4010 and keep it pressed. The SRU 4010 now starts emitting all known `TV off ' signals, one by one. Each time a code is sent, the Standby key lights up. ­ When your TV switches off (stand-by), immediately release the Standby key of the SRU 4010. The SRU 4010 has now found a code that works on your TV. Check if you can operate all functions on your TV with the SRU 4010. If this is not the case, you can redo the automatic setting. The SRU 4010 will then search for a code that works better. After the SRU 4010 has run through all the known codes, the search will stop automatically and the Standby key stops blinking. The illustration on page 3 gives an overview of all keys and their functions. 3 Red, green, yellow and blue fasttext keys. [. . . ] It is possible that you must enter another code for the device. Disposal of your old product Your product is designed and manufactured with high quality materials and components, which can be recycled and reused. When this crossed-out wheeled bin symbol is attached to a product it means the product is covered by the European Directive 2002/96/EC. please inform yourself about the local separate collection system for electrical and electronic products. [. . . ]