User manual PHILIPS SRU5107WM

[. . . ] Register your product and get support at www. Codes are stored in the permanent remote control memory so you will not lose any codes stored while you are changing batteries · The remote control automatically turns off if buttons are pressed for more than 30 seconds. This will save your batteries in case the remote control gets stuck in a place where the buttons remain pressed (e. Some buttons on the remote control might have functions that are referred to by different names on the device you are controlling. [. . . ] For example, if you have a TV / DVD combo, you need to set up one code under the TV button to control the TV part and a separate code (under any other Mode button) to control the DVD part. When setting the remote control up for your devices, the remote control copies the Volume / Mute settings as follows: · If a device has its own Volume / Mute buttons in the remote control database, then these buttons will be used. You can set all devices to use the Volume / Mute buttons of a single device without needing to change to that device mode. 1 Press and hold the SETUP button until the red light indicator turns on, then release the button. 2 Press and hold the MUTE button until the red light indicator flashes off, then release the button. 3 Press and release the desired device Mode button (TV , DVR , etc. ) for Volume / Mute control, the red light indicator flashes then remains lit. ⷠThe red light indicator will blink rapidly for three seconds if the device you have selected has no Volume / Mute control. ⷠAll other devices will now use the Volume / Mute buttons of the selected device. ⷠThe selected device will now use its own Volume / Mute control. The equivalent button functions can be found on your Philips remote control. 1 Turn on the device by pressing the corresponding Mode button for more than 1 second. 2 Press and release the POWER (y) button to turn off the device. This method can be applied similarly to any device and is available for all device modes. Note that this feature is not supported by all codes. For example, if your combo device is a TV / DVD then its original remote control might have separate TV and DVD buttons for selection of the combo part you wish to operate. The equivalent button functions can be found on your Philips remote control by using the device Mode and SETUP buttons. You can change which Volume / Mute buttons are used for a device (e. Then press and immediately release the DVD mode button to select DVR. This method can be applied similarly to all Combo devices (TV / DVR, TV / VCR, DVD / DVR, etc. ) and is available for all device modes. Note that this feature is not supported by all codes. [. . . ] Do not move or change the distance between the two remote controls until you have learned all the required buttons for the selected mode. When learning, do not release the button being learned until the red light indicator has flashed off for half a second. Avoid learning your original remote control Volume / Mute buttons unless you are sure these operate the same device e. Some original DVD remote controls include TV Volume / Mute button control and can have two different types of code. [. . . ]