User manual PHILIPS SRU5120

[. . . ] If the device does not respond at all or not to all of the key commands, follow the instructions under `Setting the remote control', or for online setup go to: www. This is only necessary if your device does not respond to the SRU 5030. If that is the case, the SRU 5030 does not recognize the brand and/or model of your device and you need to program the remote control to do so. The example below (TV) instructs you how to do this. [. . . ] Check if you can operate all functions on your TV with the SRU 5030. If this is not the case, you can redo the automatic setting. The SRU 5030 will then search for a code that works better. After the SRU 5030 has run through all the known codes, the search will stop automatically and the TV key stops flashing. 2 Look up the brand of your TV in the code list at the back of this manual. One or more four-figure codes are shown for each brand. Com/urc you can directly select your device typenumber to find the right code. Make sure you use the codes from the correct table. Keep keys 1 and 3 pressed simultaneously for three seconds until the TV key flashes twice and then remains lit. Then enter the code noted in step 2 using the digital keys. If the key flashes once for an extended period, the code has not been entered properly or the wrong code has been entered. If you want to add a function to the SRU 5030, you can contact the Philips service line for Universal Remote Control to ask for the 5-figure code for the extra function. Restoring the original functions of your remote control 1 Keep keys 1 and 6 on the SRU 5030 pressed Simultaneously for three seconds, until the mode key (TV, DVD or VCR) flashes twice and then remains lit. All original functions have now been restored and any extra functions have been deleted. ­ Problem Solution The mode keys (TV and DVD/VCR) blink four times after every key press. The remote control is indicating that its batteries are running low. Replace the old batteries with two new AAA batteries. The device you want to operate does not respond and the mode key (TV, DVD or VCR) does not flash when you press a key. Replace the old batteries with two new AAA batteries. The device you want to operate does not respond but the mode key (TV, DVD or VCR) does flash when a key is pressed. Point the SRU 5030 at the device and make sure that there are no obstructions between the SRU 5030 and the device. the SRU 5030 does not respond properly to commands. [. . . ] You can solve most of the problems yourself. If you cannot find any answers to your problems, write down the details of your device shown in the code list at the back of this manual. This will help our operators to assist you better and more quickly. Look up the numbers of the models in the instructions accompanying the device or on the back of your device. [. . . ]