User manual PHILIPS SRU6080

[. . . ] 13 Setting any Mode to use its own Volume/Mute . Congratulations on your purchase of Philips Universal Remote Control. Philips Universal Remotes let you replace a broken or lost remote or combine more than one remote into one. In addition, this remote is equipped with a command learning feature which lets the remote learn commands from your original equipment remote control! [. . . ] Assuming the DVD/VCR Combo device is the example and its code is programmed under DVD Mode, press and hold the DVD Mode button for more than one second to send the DVD button command. To send the VCR button command, quickly press and release the SETUP button followed by pressing and releasing the DVD Mode button. This method can be applied similarly to all Combo devices (e. Note this feature is not supported by all codes. Setting any Mode to use its own Volume/Mute Control (MODE VOL. SET) This sets any Mode to use only its own Volume/Mute control, i. Note - If your chosen Mode has no Volume/ Mute functions of its own then the Volume/Mute buttons will do nothing. Press and hold the SETUP button until CODE SETUP is displayed (takes about 3 seconds), then release the SETUP button. Press the down navigation button until SYSTEM SETUP is displayed. Press the down navigation button until MODE VOL. Press and release desired Mode key (TV, VCR, DVD, etc. The chosen Mode will now use its own Volume/Mute control. Resetting Volume/Mute Control to Factory Defaults (VOL/MUTE RESET) This resets Volume/Mute control back to its Factory default settings. Press and hold the SETUP button until CODE SETUP is displayed (takes about 3 seconds), then release the SETUP button. Press the down navigation button until SYSTEM SETUP is displayed. Press the down navigation button until VOL/MUTE RESET is displayed 6. Volume/Mute control is now rest to its Factory default settings. Press and hold the SETUP button until CODE SETUP is displayed (takes about 3 seconds), then release the SETUP button. Press the down navigation button until SYSTEM SETUP is displayed. Press the down navigation button until TIME SETUP is displayed. Use the Up/Down navigation buttons to set the format (12Hr or 24Hr) then press and release OK. Use the Up/Down buttons to set the hours then press and release OK. [. . . ] For example, to enter a delay of 3 seconds, press and release PAUSE followed by 3 (in step 6 of "To Setup a Macro" on the previous page). It is not possible to have a "0" digit entered after Pause i. There is an automatic delay of half a second between each IR transmission in a Macro sequence. Press and hold the SETUP button until CODE SETUP is displayed (takes about 3 seconds), then release the SETUP button. [. . . ]