User manual PHILIPS SRU7040

[. . . ] Press the key until the TV LED lights up. If the LED does not light up, check whether the battery is properly inserted (see `Replacing the battery'). For an overview of the keys and their functions see `3. If the TV responds as it should to all of the key commands the SRU740 is ready for use. [. . . ] Check if you can operate all functions on your TV with the SRU740. If this is not the case, you can redo the automatic setting. The SRU740 will then search for a code that works better. After the SRU740 has run through all the known codes, the search will stop automatically and the TV LED will stop flashing. English 7 Manually setting the remote control Example of TV: 1 Turn on the TV manually or use the original remote control. 2 Look up the brand of your TV in the code list at the back of this manual. One or more four-figure codes are shown for each brand. Com/urc you can directly select your device typenumber to find the tight code. Make sure you use the codes from the correct table. Press the key until the TV LED lights up. Keep keys 1 and 3 pressed simultaneously for three seconds until the TV LED flashes twice and then remains lit. Then keep keys 1 and 6 on the SRU740 pressed simultaneously for three seconds, until the SAT LED lights up. Press the key until the TV LED lights up. SAT will now allow you to operate your second TV. If you want to add a function to the SRU740, you can contact the Philips service line for Universal Remote Control to ask for the 5-figure code for the extra function. Instructions for use Assigning the volume control to another mode The volume controls (Vol +, Vol - and s) on the SRU740 are assigned to either your TV or your amplifier/receiver, depending on the device you have selected: MODE VOLUME CONTROLS TV mode selected . With TV with TV with TV with amplifier/ receiver If you want a different setup, the volume control assignment can be changed. Press the key until the SAT LED lights up. Then keep keys 1 and 6 on the SRU740 pressed simultaneously for three seconds, until the SAT LED flashes twice and then remains lit. Press the key until the SAT LED lights up in the selector window. Restoring the original functions of your remote control 1 Keep keys 1 and 6 on the SRU740 Pressed simultaneously for three seconds, until one of the LEDs (TV, SAT, DVD/VCR, AMP) lights up. All original functions have now been restored and any extra functions have been deleted. [. . . ] None of the codes works during manual setting of the remote control. If you have any questions about the SRU740/10, you can always contact us. You will find our contact details after the code list at the back of this manual. Read this manual carefully before you make a call. [. . . ]