User manual PHILIPS SRU7060

[. . . ] Selects next / previous favorite station (TV, STB). Stops at the current Teletext picture (TV, STB). Using the Shift key The SHIFT key is used to access additional functions for the current device mode e. Press other keys to find out which functions are available for the selected device mode. [. . . ] 4 Press and hold SETUP until the device mode indicator blinks and then remains lit, then release the key. 5 Use the number keys to enter the 4 digit code, noted in step 1. The remote control is now ready to operate your device. If some buttons do not operate your device, try one of the other codes for your brand. Code Search If your device does not respond after you have tried all the codes for your brand, or if your brand is not listed, try searching for your code using code search. code Search starts from the currently stored code. Automatic Code Search The remote control will automatically search for the right code for your device. 3 Press and hold SETUP until the device mode indicator blinks and then remains lit, then release the key. ­ The remote control now starts emitting all known Program + commands to your device one by one. The device mode indicator turns off with each command sent. If the device does not use a PROG+ key then the (Standby) key can be used instead. You may need to adjust the height of either remote to achieve this. Do not move or change the distance between the remote controls while learning. You can store a function under any of the available keys, except under LEARN, SELECT, SHIFT and SETUP. Some functions of some types of remote control might not be learned. Use fresh batteries for both the learning and the original remote control. Place both remote controls on a flat surface (like a coffee table) and aim them head-to-head with about 30 mm in between. You may need to adjust the height of one of the remote controls to achieve this. Press and hold SETUP until the device mode indicator blinks and then remains lit, then release the key. The device mode indicator blinks once, then remains lit. Press the key you wish to learn a new function to (target key). For additional (shifted) functions, first press SHIFT, then press the function key. [. . . ] Program the remote control with a new code. Device mode indicator blinks for Remote control may not be able 3 seconds after you program a to operate all features of your product code. Product or key names might be different than on your product. remote control did not accept the code. [. . . ]