User manual PHILIPS STU130A

[. . . ] 2 Connect the mains lead to the AC MAINS ~ socket and the wall socket. The mains supply is now connected and ready for use. 3 To switch off completely, withdraw the mains lead from the wall socket. € Disconnect the mains lead from the wall socket to protect your set during heavy thunderstorms. [. . . ] RADIO Radioempfang 1 Turn the VOLUME/POWER OFF knob clockwise to switch on the radio and adjust the volume. 5 mm plug to the socket p - The built -in speaker will be muted. 2 Select the wave band using the BAND switch. 3 Tune to a radio station using TUNING. € For FM, pull out the telescopic aerial. Reduce its length if the signal is too strong (very close to a transmitter). € For MW (AM or LW) the set is provided with a built-in aerial so the telescopic aerial is not needed. Direct the aerial by turning the whole set. 4 Adjust the TONE switch by selecting NEWS or MUSIC. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp. Severe radio hum/distortion Grésillements/déformation importants du signal radio Acusada distorsión/zumbido en la radio Heftiges Brummen/Rauschen – FM aerial not fully extended • Extend FM aerial fully Continuous crackling/hiss disturbance during MW (AM/LW) broadcast – Electrical interference from TV, computer, fluorescent lamp, etc. € Rücken SIe das Gerät weg von anderen Elektrogeräten CAUTION Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Note: The severed plug must be disposed of to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere. How to connect a plug The wires in the mains lead are coloured with the following code: blue = neutral (N), brown = live (L). As these colours may not correspond with the colour markings identifying the terminals in your plug, proceed as follows: • Connect the blue wire to the terminal marked N or coloured black. € Connect the brown wire to the terminal marked L or coloured red. € Do not connect either wire to the earth terminal in the plug, marked E (or e) or coloured green (or green and yellow). Before replacing the plug cover, make certain that the cord grip is clamped over the sheath of the lead - not simply over the two wires. [. . . ] Before replacing the plug cover, make certain that the cord grip is clamped over the sheath of the lead - not simply over the two wires. Environmental information Unnecessary packing materials has been omitted to make the packing easy to separate into 2 categories: cardboard and paper pulp. Our unit consists of materials which can be recycled if disassembled by a specialized company. Please observe local regulations on the disposal of packing materials and old equipment. [. . . ]