User manual PHILIPS SWV4133S

[. . . ] When selecting single-digit channels, press the number of the desired channel. The TV will pause for a few seconds and then tune to the selected channel. (Note: You can press 0, then the number also. ) For channels 100 and above, first press 1 then the next two numbers of the desired channel. [. . . ] Press again to return the sound to its previous level. QuadraSurfTM Buttons - (Red, Green, Yellow, Blue) Allows you to store and surf up to 10 channels you choose for each colored button. Program List Button - Press to display a list of channel numbers and their names. Each channel that is being blocked by AutoLockTM will appear with a padlock icon to indicate that the channel is not viewable. TV/VCR (A/CH) Button - TV/VCR ­ Press while in the VCR mode (the VCR indicator on the front of the VCR will light) to view the playback of a tape. Press again to place in the TV position (the VCR indicator light will go off) to view one program while recording another program. The signal being received during the time the picture is frozen will be lost. When the picture is unfrozen, the video will return to real time broadcast. Volume and Channel buttons are located on the top of the television cabinet. Note: You can also press any button on the front of the TV to turn the TV ON. Press the VOLUME + button to increase the sound level, or the VOLUME ­ button to lower the sound level. NOTE: Press the AV button or use the CH+ or CH- on the TV remote control to tune to the AV1 channel for the cable box signal. Once tuned, change channels at the cable box, not the television. He TV's audio/video input jacks are for direct picture and sound connections between the TV and a VCR (or similar device) that has audio/video output jacks. Both the AV1 and AV2 Input Jack connections are shown on this page, but either one can be connected alone. Follow the easy steps below to connect your accessory device to the AV1 and AV2 IN Jacks located on the back of the TV. Connect the VIDEO (yellow) cable to the VIDEO OUT jack on the back of the VCR (either one or two) or accessory device being used. Audio and video cables are not supplied with the TV, but are available from Philips or electronics retailers. He S(uper)-Video connection on the rear of the TV can provide you with better picture detail and clarity for the playback of accessory sources such as DBS (digital broadcast satellite), DVD (digital video discs), video games, and S-VHS VCR (video cassette recorder) tapes than the normal antenna picture connections. NOTE: The accessory device must have an S-VIDEO OUT(put) jack in order for you to complete the connection on this page. Connect other end of the SVIDEO CABLE to the S-VHS (S-Video) OUT jack on the back of the VCR. Then connect the other ends of the AUDIO (red and white) CABLES to the AUDIO (left and right) OUT jacks on the rear of the VCR. [. . . ] AUDIO SYSTEM CONNECTION: Connect one end of the R(ight) and L(eft) AUDIO (Monitor Out) jacks on the TV to the R and L audio input jacks on your amplifier or sound system. To adjust the volume on the audio system, you will need to change the volume at the external audio system, not the television. Audio Cables SECOND VCR CONNECTION: (Red and White) NOTE: Refer to panel number 6 for the proper hookup of the first VCR. SECOND VCR CONNECTION: Follow the instructions on how to tune to the AV1 channel to view a pre-recorded tape. [. . . ]