User manual PHILIPS TD5250-BB059P

[. . . ] In the interest of improving our products and services. Philips reserves the right to alter the specifications contained in this document at any time without prior notice. · · · Battery charging starts as soon as you place the handset on its base. A completely discharged handset will take about 24 hours to charge. With a fully charged new battery, your handset will be able to operate for about 8 hours on-line and about 8 days on stand-by (in other words when not communicating). [. . . ] This function allows you to dial it automatically. The direct memory function is only available if the base station is powered by the mains supply and if the handset battery is charged. To ensure correct operation, stay close to the base station during the programming phase. Setting up your Icana 5250 1 On the top side of the base station, connect the telephone cable to the smaller of the sockets and then to the telephone socket in the wall. Connect the power supply cable to the larger of the sockets on the base station and then to the power outlet. The indicator light on the base station lights up. Your telephone is now correctly connected. Place the handset on its base station and leave it to charge for at least 15 minutes. Your telephone has two possible dial modes: "tone" or "pulse". The factory setting for your telephone is "tone". If you are not connected to an electronic central exchange, you need to use "pulse". To set the dial mode from "tone" to "pulse": 2 1 Pick up the handset and press ®. The indicator light on handset starts flashing. Press the key. 2 1 2 3 Press the direct memory key The phone indicator light flashes. on the handset. key. Press the Your handset emits 3 beeps to confirm. The telephone is now ready to dial in "pulse" mode. 2 Dial the number to be memorised (maximum of 23 digits). If this number contains an area or other code, insert a pause after the code by pressing If you insert a wrong number, you will have to start the procedure again. This key now corresponds to the telephone number you just dialled. The phone indicator light goes out and the handset emits the 3 confirmation beeps. on the handset. 3 4 Mains power supply Telephone line To set the dial mode from "pulse" to "tone": 1 Pick up the handset and press ®. The indicator light on handset starts flashing. Press the key. Your telephone is now ready to make or receive calls in "Tone dialling" mode. 2 To charge the battery completely, leave the handset on its base station for 24 hours. The telephone is now ready to dial in "tone" mode. If you do not hear the 3 confirmation beeps, the number you just dialled has not been saved. Start the procedure again from step 1 . Answering a call 1 To answer: pick up the handset, fully extend the antenna, and press the key. · When your telephone line is connected to an electronic exchange, the "tone" mode provides faster dialling and access to special telephone network services. Calling the number associated with the direct memory key 1 Extend the handset antenna, press the TALK key dial tone. [. . . ] Several cordless telephones may be in use in the same building. This often creates communications problems as a result of radio link congestion. Your Philips telephone is fitted with a multichannel system which automatically searches for a free channel, thereby avoiding any inconvenience. even change channels during your call using the If unfortunately, something should go wrong with this product, Philips guarantees free of charge labour and replacement parts irrespective of the country where it is repaired during a period of 12 months from date of purchase. [. . . ]