User manual PHILIPS TD5350-BB058P

[. . . ] telescopic antenna Thank you for purchasing a Philips Icana 5350 cordless telephone Your Icana 5350 cordless telephone incorporates advanced Philips cordless technology for even greater simplicity and user-friendliness. earpiece Your Icana 5350 is fitted with a multi-channel radio system, which allows you to avoid interference during calls using the D2NS system (Dual Dynamic Noise Suppressor) to eliminate hiss. Your Icana 5350 is fitted with a liquid crystal display screen on the handset, giving you all the features of a real phonebook - 25 names and telephone numbers. You can also identify the telephone number of the caller (Caller ID)* and consult the Caller ID list*. [. . . ] ­ ­ ­ ­ 2 Your handset display These symbols tell you what is happening on your phone. The display of your Icana 5350 has 6 symbols: indicates that: ­ you are programming your phone. indicates that: ­ you are consulting or modifying your phonebook. indicates that: ­ you have the line (flashing) or a call is in progress (on). indicates that: ­ new calls have been stored in the caller list since your last consultation (on). ­ a network message is sent (flashing). indicates that: ­ the base station loudspeaker is on. indicates that: ­ when on the base station, the handset is charging. ­ when out of the base station, the batteries are not charged enough (flashing). This line of the display shows up to 10 numbers or characters. * When your telephone line is connected to an electronic exchange, the "tone" mode provides faster dialling, and access to special telephone network services. Answering a call 1 To answer: pick up the handset, fully extend the antenna, and press the key. When the phone rings, the telephone number of the caller is displayed (if you subscribe to the caller identification service). Once the call is answered, the call timer is displayed. key again, or just To hang up: press the replace the handset on the base station. The display shows the call time for 5 seconds. 3 to . Press the Loop Disconnect Signalling: Although this equipment can use either loop disconnect or DTMF signalling (Tone dialling), only the performance of the DTMF signalling (Tone dialling) is subject to regulatory requirements for correct operation. It is therefore strongly recommended that this equipment is set to use DTMF signalling (Tone dialling) for access to public or private emergency services. DTMF signalling (Tone dialling) also provides faster call set up. To validate the last character (letter or digit) typed, wait for 3 seconds or press another character. To delete the last character typed, press the key. To type a space between two letters, press the twice. Press the RECORD is displayed for 2 seconds. The handset emits 3 confirmation beeps. symbol and the handset indicator light are switched off. Press the symbol and the handset This key is now associated with the telephone number you just dialled. [. . . ] There is dirt on the charging contacts. symbol remains lit once the call is received. Lift up the handset then put it back on the base station. Clean the charging contacts with a clean cloth or pencil eraser. 2 3 The line indicator light on the handset remains lit even when a call is not in progress. There is no dialling tone. The handset hasn't been put down properly. Press the key and replace the handset on the base station. Changing the handset battery Contact your local Philips dealer to obtain a new battery. · · The base station is not connected properly to the telephone line. The handset battery is discharged. · · · Check the connections. Place the handset on the base station and wait for at least 15 minutes. [. . . ]