User manual PHILIPS TD6816

[. . . ] · 2 standard AA/R6 rechargeable batteries. This guide shows you how to install and use your Onis extra handset. Please refer to the corresponding Onis user manual for information on: · using the phonebook, · using the answering machine (Onis memo and Onis Vox only), · troubleshooting. Note: You should also refer to the manufacturer's handbook corresponding to the base station with which you are using this handset. 6 Introduction Installing your extra handset Deciding where to put the charger · Place the charger near a main outlet supplying 220-240V at 50Hz. · To reduce to a minimum any interference with other electronic devices such as telephones, televisions, screens, etc. we advise you to place your charger at least 50 cm from any other electronic device. · Place the charger on a flat surface as with the base station or mount it on a wall. [. . . ] If the base station has no name, BASE NAME?You can enter characters by pressing the key with the required character on it one or more times. These characters are engraved on the handset keypad. If you wish to enter two successive characters which are on the same key, you need to distinguish them by pressing the - key between the two characters. For example: to enter PHILIPS you would press the following keys. 7 P 4 Press 44 H - 444 I 555 L 444 I 7 P - 7777 S o. Press R to leave menu mode. Installing your extra handset 11 Using your extra handset Making an outside call Direct dialling 1 Press the t key on the handset. The t symbol is shown on the display and you hear the dial tone in the handset earpiece. The number called is displayed for 10 seconds after the last key is pressed. If the number you enter is longer than 10 digits, the display will scroll the number to the left to show the last digits. To hang up, press t or replace the handset in the charger. The duration of your call in minutes and seconds is displayed for 4 seconds. 2 3 Dialling with number preparation This way of dialling allows you to make corrections to the number before dialling. 1 Dial the number (up to 23 digits) before pressing the t key. You can use the + key to make corrections by cancelling the last digit entered. If the number you enter is longer than 10 digits, the display will scroll the number to the left to show the last digits. Tip If you want to see the whole number you have dialled so far, press o. The number will scroll to the left if it is longer than 10 digits. 12 Using your extra handset 2 Press the t key on the handset. The number prepared is automatically dialled. The handset loudspeaker is activated and the number is dialled. To hang up, press t or replace the handset in the charger. The call duration is displayed for 4 seconds. 3 Answering an outside call When someone calls you, the base station and the extra handset ring, the t symbol blinks on the extra handset display and the green light on the base station flashes. The t symbol stops blinking on the handset. The green light on the base station blinks regularly to indicate that a call is in progress. The handset loudspeaker is activated and you can take the call. [. . . ] - Switch back and forth between the other handset and your outside call by using e. In case of replacement, you must use the following approved batteries: PHILIPS R6 NC-P, Saft RC6. The manufacturer is not liable if these recommendations are not respected. 1 2 3 Slide down and lift off the battery cover. [. . . ]