User manual PHILIPS TD6831

[. . . ] - Methods of Transport within the UK: Please be aware whichever method of transport is chosen it is the consumers' responsibility to package the faulty unit for return to a level which prohibits accidental damage. Philips is not responsible for damage/loss caused during carriage to the Service Centre. Freepost: Please write the following address onto your package. This method of transport will take 2-3 working days to reach the Service Centre. [. . . ] Each HANDSET may be used with two different BASE STATIONS. Before commencing the following, the handset must be fully charged for at least 12 hours. 1 Unplug and plug back in the power supply of the Onis 200 BASE STATION. " for a short while, followed by "Set!First, follow the procedure described by the manufacturer (see base station manufacturer's instructions). Once this is done, follow steps 2 to 4 of the procedure shown above for the HANDSET. Use a damp, lightly soaped cloth to clean your HANDSET. Clean your telephone regularly to keep it looking brand new. Important: Do not place your telephone in a place where it may fall. Using the handset with an ONIS 200 base station The additional HANDSET functions in the same manner as the handset which comes with your Onis 200 or Onis Vox 200 BASE STATION. With this multi-handset setup you can now: - make conference calls, - transfer calls, - make an external call with two other HANDSETS in an intercom mode (if you have 3 or more HANDSETS). Using the handset with another GAP standard base station the GAP standard guarantees minimum operating performance for all handsets and base stations , irrespective of their make. Your HANDSET conforms with this standard. In order to get the most out of your HANDSET, we recommend you read both these and the manufacturer's instructions. When your HANDSET is used with a different make of base station, line connection, call reception and dialling functions are guaranteed. 1 Make two holes in the wall, 65mm apart vertically and insert screws. 2 Mount the base using the plastic attachment and pull down. The telephone will work for approximately one week when the HANDSET is away The icon indicates a charge level from the BASE STATION in idle mode and around 15 hours when in use. â· During a call, beeps will provide a warning when only a few seconds of battery life below 5% (no bar). You should now charge the HANDSET remain. Communication will be cut off automatically when after this time. It takes at least 12 hours to fully recharge an empty battery. [. . . ] To scroll through the list and select the extensions you wish to make the call. You may also enter the number of the handset you wish to call or to make all handsets ring. In this case, steps 2 and 3 become redundant. If you receive an external call while in intercom mode, beeps will alert the handsets in use. [. . . ]