User manual PHILIPS TSU9200

[. . . ] The following keys send commands to your equipment without activating the screen: Channel Up/Down, Volume Up/Down, Menu, Guide, Power, Mute Note Battery level Buttons on the touch screen These buttons are used to · Firm keys Firm key actions are activity-related and may vary depending on the page displayed on screen. Hard keys on the Control Panel The hard keys on the Control Panel have set functions in the various Home Theatre activities. The screens on your Control Panel are customised by your installer and may differ in appearance from that shown above. Power switch The Power switch on the bottom of the Control Panel turns the Control Panel on and off. [. . . ] Always switch the Control Panel off during transport to prevent the touch screen from being activated and draining the battery. Normally, your installer will have fully programmed your Control Panel and no changes are required. Version and network information as well as memory status can be found on the Info Page. General volume covers all the sounds you hear when you operate the Control Panel. Button volume applies specifically to the default sound you hear when you press a button. Tap the buttons to toggle between the various Activation settings: Pick up sensor: the Control Panel switches on when it is tilted. Firm keys: the Control Panel switches on and/or sends out an IR signal when a firm key is pressed. Cursor keys: the Control Panel switches on and/or sends out an IR signal when one of the cursor keys is pressed. Do not use this function unless you experience problems with the touch screen. My Control Panel rapidly runs out of power ⷠBear in mind that the Control Panel is still using power when operating in a WiFi environment, even while its screen is black. It is recommended that the Control Panel be placed in its docking station each time after use. ⷠIf the battery runs out of power constantly, it may be due for replacement. Contact your installer for more information. 4 GHz 64 MB SDRAM 64 MB NAND Flash Power on by tilting, tapping the screen, pressing the back light button or tapping a key Power off automatically on timeout Battery status indication 6. Reproduction in whole or in part is prohibited without prior consent of the copyright owner. Royal Philips Electronics cannot be held liable for omissions or for technical or editorial errors in this manual or for any loss or damage resulting directly or indirectly from the use of the Pronto Control Panel. The information in this Starter's Guide may be subject to change without prior notice. All brand or product names are trademarks or registered trademarks of their respective companies or organisations. [. . . ] All brand or product names are trademarks or registered trademarks of their respective companies or organisations. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: · This device may not cause harmful interference. ⷠThis device must accept any interference received, including interference that may cause undesired operation. [. . . ]