User manual PHILIPS TT 2020

[. . . ] With this new rechargeable shaver and trimmer in one you can easily shorten and remove body hair wherever you like, wet or dry!Using the appliance Take your time when you first start to shave sensitive areas. You have to acquire practice with the appliance. Your skin also needs some time to adjust to the procedure. [. . . ] Do not cut off the adapter to replace it with another plug, as this causes a hazardous situation. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. check if the voltage indicated on the appliance corresponds to the local mains voltage before you connect the appliance. Children should be supervised to ensure that they do not play with the appliance. Never immerse the charger in water nor rinse it under the tap. If the adapter is damaged, always have it replaced with one of the original type in order to avoid a hazard. Do not use the appliance if the shaving foil or the trimming comb is damaged or broken, as this may cause injury. This appliance is only intended for shaving and trimming body parts below the neckline. Compliance with standards The appliance complies with the internationally approved IEC safety regulations and can be safely used in the bath or shower (Fig. This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled properly and according to the instructions in this user manual, the appliance is safe to use based on scientific evidence available today. Charging 1 Insert the small plug into the charger (Fig. Do not apply too much pressure and stretch the skin properly when you move the shaver across it. Hair growth while you press it lightly (Fig. Make sure that the shaving head is always fully in contact with the skin. Trimming The trimming comb allows you to cut hair to an even length of 3mm. 1 Snap the trimming comb onto the 4 Move the appliance against the direction of The motor run until the battery is completely empty. 2 Remove both side panels from the appliance 3 Separate both housing parts to open the 4 Lift the power unit out of the appliance. [. . . ] Off the cutter block and the shaving foil. Make sure that you also brush away any hairs that have collected under the trimmers (Fig. Note: Lubricate the shaving foil with a drop of sewing machine oil twice a year. Replacement In case of very frequent use, replace the shaving head (type number TT2000) every year. [. . . ]