User manual PHILIPS TV-VCR 25 IN 4 HD CCA255AT

[. . . ] And take advantage of these important benefits. Warranty Verification Registering your product within 10 days confirms your right to maximum protection under the terms and conditions of your PHILIPS MAGNAVOX warranty. Owner Confirmation Your completed Warranty Registration Card serves as verification of ownership in the event of product theft or loss. Model Registration Returning your Warranty Registration Card right away guarantees you'll receive all the information and special offers which you qualify for as the owner of your model. I ST RATION N Know these S REG y!urr H IT safetysymbols CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. EE DED AY W Dear PHILIPS MAGNAVOX product owner: Thank you for your confidence in PHILIPS MAGNAVOX. You've selected one of the best-built, best-backed products available today. [. . . ] There are three playback speeds: SP, LP, and SLP. During playback, the VCR selects the tape speed automatically. When recording, you can change the tape speed using the SPEED button (see page 23). Tape Speed Maximum Record/Playback Time Type T160 T120 T60 SP 2 hrs. (Super Long Play) 30 One-Touch Recording The One-Touch Recording (OTR) function allows you to program an immediate timed recording from 30 minutes to eight hours long without setting the timer. Before you begin, make sure: q Channels are set up. The record tab must be intact. 4 Press the STOP/EJECT button on the TV/VCR to stop the OTR. 1 POWER SLEEP Use the CHANNEL o/p buttons or the Number buttons to select the channel you want to record. ALT. CH 1 4 7 2 5 8 0 3 6 9 +100 MUTE o CHANNEL Press the SPEED button until the desired recording speed (SP, LP, or SLP) appears on-screen. Details are on page 29. 2 p 2 o o VOLUME 1 SPEED p o PLAY o REW STOP F. FWD Press the REC(ord)/OTR button repeatedly until the desired recording length appears in the upper right corner of the screen. The REC(ord) light will appear. OTR CH12 LENGTH 0:30 3 3 p REC/OTR MEMORY PAUSE/STILL o MENU STATUS/EXIT CLEAR TRACKING p LENGTH : PRESS OTR CANCEL : PRESS CLEAR 4 Helpful Hints · To check the time remaining for an OTR after the OTR has been set, press the STATUS/EXIT button. · To change the recording length while an OTR is in progress, press the REC(ord)/OTR button until the desired recording length appears on-screen. · To cancel an OTR but continue recording, press the REC(ord)/OTR button, then press the CLEAR button. q WEEKLY: The TV/VCR will record the same channel on the same day, at the same time, and for the same length of time every week. Daily Recording (example) DAILY PROGRAM (MON-FRI) PROGRAM -1 2 3 4 5 6 7 8- Helpful Hints · If the power fails, programmed timer recordings will be restored when the clock is reset. (The clock will reset itself automatically if you are using the AUTO CLOCK feature. If you are not using the AUTO CLOCK feature, reset the clock manually. Details are on pages 13 - 14. ) The timer recording will not occur only if the timer recording was scheduled to take place during the power failure. · You cannot set a timer recording if DEFEAT RECORDING is set to ON. Details are on page 36. SELECT PROGRAM NUMBER TO END PRESS EXIT Timer Recording (cont'd) 33 4 Use the Number buttons (1 - 8) to select a position in which to store the timer recording. Flashing numbers indicate an open position (one in which a timer recording has not yet been stored). NOTE: If you select a number that has already been used to store a timer recording, PREVIOUSLY SET PROGRAM will appear on-screen for a few seconds. Then information about the program in that position will appear on-screen. If this happens, press the STATUS/EXIT button. [. . . ] · incidental or consequential damages resulting from the product. (Some states do not allow the exclusion of incidental or consequential damages, so the above exclusion may not apply to you. This includes, but is not limited to, prerecorded material, whether copyrighted or not copyrighted. ) · damage caused by the use of non-VHS tapes or tapes that have not been tested and labeled for use in two, four, six, and eight hour VHS recorders. · a product that is used for commercial or institutional purposes. [. . . ]