User manual PHILIPS US2-PHBIG3

[. . . ] Some products require Enter to be pressed after channel selection. ENTER Used after direct channel number entry to immediately change to the selected channel. RECORD, PLAY, STOP, REW, FF, PAUSE VCR control buttons operate your VCR even when the remote is set to operate the TV. TV/VCR For some TVs, press repeatedly to select from available viewing sources (antenna, cable box, VCR, etc. [. . . ] Code Search starts from the currently stored 4 digit number under that mode. The Code Identification Feature allows you to identify the 4 digit library code stored under your device key. For example, if you want to find out what 4 digit code is stored under your TV device key, follow the six steps below: 1. To find the first digit for the code stored under the mode key pressed in step 2, press each numeric key from 0-9 in turn. When the red indicator blinks off the number you pressed is the first digit for the code you are searching for. To find the second digit, repeat step 4, this time when the red indicator blinks off this is the second digit. Repeat step 4 to find the third and fourth digits. Lets you search for a code for a specific Brand within the Code Library for a particular manufacturer. Press and hold the CODE SEARCH button until the red indicator remains on, then release CODE SEARCH button. Press the CHANNEL UP button ((or POWER or PLAY (VCR only)) repeatedly until the device to be controlled changes channel. the red indicator blinks off with each button press. If you accidentally overshoot the code required, press the CHANNEL DOWN button to backtrack through the library until the device changes channel. Pressing CHANNEL UP changes direction to forward again. ) will require you to set up two different Mode buttons to control both parts of the Combo device. For example, if you have a TV/DVD Combo, you might need to set up one code under the TV button to control the TV part AND a separate code (under any other Mode button) to control the DVD part. For example, if your Combo device is a DVD/VCR then its original remote might have separate DVD and VCR buttons for selection of the Combo part you would control. The equivalent button functions can be found on your Philips remote by using the device Mode and CODE SEARCH buttons. DVD) with the correct code for your Combo device. Assuming the DVD/VCR Combo device is the example and its code is programmed under DVD Mode, press and hold the DVD Mode button for more than one second to send the DVD button command. To send the VCR button command, quickly press and release the CODE SEARCH button followed by pressing and releasing the DVD Mode button. This method can be applied similarly to all Combo devices (e. Note this feature is not supported by all codes. [. . . ] Remote does not operate some features of your product. Remote may not be able to operate all features of your product or button names might be different than your product. Try to program the code again or try a different code. The manufacturer warrants that this product shall be free from defects in material, workmanship and assembly, under normal use, in accordance with the specifications and warnings, for as long as you own this product. [. . . ]