User manual PHILIPS US2-PHDTV1

[. . . ] Some functions of your particular equipment (e. Menu functions) may not be controlled by this remote. In such cases, use the original remote control for your equipment. Please use this manual to become familiar with your Philips Universal Remote. [. . . ] Press and hold the CODE SEARCH button until the red indicator stays on, then release the CODE SEARCH button. Enter the 4 digit code from the code tables (on separate sheet). Note: after a valid code entry, the red indicator turns off. Note: If some buttons do not operate your equipment, try one of the other codes for your brand. Write your codes down here for easy reference later. If (for example) you want to store a VCR code under CABLE, first follow the procedure for Direct Code Entry (previous page) and press CABLE in step 2 of Direct Code Entry, then enter ANY VCR code in step 3 of Direct Code Entry. Then follow the steps above for Code Search (or Brand Search, below). Note: If the device does not have a CHANNEL UP button, use PLAY (VCR only) or POWER instead. Code Search starts from the currently stored 4 digit number under that mode. Lets you search for a code for a specific Brand within the Code Library for a particular manufacturer. Press and hold the CODE SEARCH button until the red indicator remains on, then release CODE SEARCH button. To send the VCR button command, quickly press and release the CODE SEARCH button followed by pressing and releasing the DVD Mode button. This method can be applied similarly to all Combo devices (e. Note this feature is not supported by all codes. The equivalent button functions can be found on your Philips remote by using the device Mode and POWER buttons. TV) with the correct code for your device. Assuming a TV device is the example and its code is programmed under TV Mode, to turn your TV on, press and hold the TV Mode button for more than one second to transmit the Power On button command. Alternatively, you can enable the remote to turn off your TV after a period of 1 to 99 minutes as shown below. This feature is only available for the TV Mode and the remote must be in TV Mode to set a Sleep Timer. This feature works even if your TV does not have its own Sleep function. Press and release the SLEEP button (Note any previously set Sleep timer is cancelled at this point and the remote returns to normal operation). The red indicator blinks off to indicate button press acceptance and remains off after the second button press. [. . . ] Please refer to the next page for more information. Any Mode chosen for Volume/Mute control MUST have its own Volume/Mute function or the Volume/Mute buttons will do nothing. Setting ALL Volume/Mute Control to any one Mode This routine can set all Modes to "punch-through" to any one chosen Mode for Volume/Mute button control without the needing to change to that Mode. Press and hold the CODE SEARCH button until the red indicator turns on, then release the button. [. . . ]