User manual PHILIPS VCM7137/00T

[. . . ] If you have any problems, contact your dealer. English Warning Any unauthorized modification to this equipment may cause violation of the EMC rules resulting in the revocation of the authorization to operate the equipment. The exclamation mark within a triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. Note: We advise you to use the following types of mains power adaptors in combination with the camera: UK Philips VCM1162/01R EUR Philips VCM1162/00R g English g 2 English Colour Observation Camera Table of contents Page Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Use the power switch to switch off, only operating the power save key is not sufficient. If switching off is impracticable, use the auto install option of the system monitor's install menu. Caution: Never touch the glass of the camera lens as this may cause damage g 5 Camera position 1 Take the camera, system cable and monitor to the area you want to observe (with the monitor on site, you can check whether the camera covers the required area). Remark: For outdoor use protective camera housing has to be used to protect the camera from rain and snow. Connect the camera to the system monitor (1). Connect the system monitor to the mains (2). After about 8 seconds or when a key is pressed the camera image will appear on the monitor screen. 2 3 4 camera in slave 1 video audio in 2 3 4 max 24V 2A out power out VCR out aux out alarm gnd 3 1 2 CL 66610005_314A. AI 5 If necessary adjust contrast T/brightness ( and/or colour S (controls at the front of the monitor) to optimise the camera image. g 6 6 Hold the camera at the proposed installation position Check on the monitor whether the camera covers the required area (The best results are obtained when the camera is pointed slightly downwards and is not looking into a bright light source). Fasten the wall bracket (1) to the wall, or another even and firm surface. Tighten the knob (2). 7 1/4" 20 UNC 3 1 8 2 CL 66610005_302. AI 9 10 Fasten the camera to the bracket (3). 11 Loosen knob (4) and screw (5) slightly (figure below). 12 Direct the camera at the object or area you want to observe (8). 13 Tighten the knob (4) and screw (5) when the camera is in position. 8 5 7 100m 200m 4 0X1 0-50m 300m 24V + 0 6 CL 66610005_303. AI g 7 14 Check if the cable length compensation (6) selector is set to the correct length. [. . . ] 300-3000Hz The camera automatically synchronises to the system monitor. Without system monitor the camera generates its own synchronisation signals. [. . . ]