User manual PHILIPS VR1100

[. . . ] TABLE Safety Precautions OF CONTENTS WARNING Any unauthorized changes or modifications to this equipment void the user's authority to operate it. In the table of contents, please simply click the WARNING: DANGEROUS VOLTAGE INSIDE section you need detailed information about. WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. · The STANDBY/ON and VCR POWER buttons do not completely shut off the mains power from the unit, but switches operating current on or off only. · The rating plate is on the rear of the unit. ® 625 Table of Contents Description of Controls . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Front Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Remote Control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] "DSPC" appears blinking in the VCR's display panel during automatic tracking. (P. 23) · Playback picture quality of LP recordings will not be as high as SP recordings. · Compact VHS camcorder recordings can be played on this VCR. Simply place the recorded cassette into a VHS Cassette Adapter and it can be used just like any full-sized VHS cassette. · This VCR can play both VHS and Super VHS signals using Super VHS cassettes. 3Start Playback To stop playback Press 7 STOP. To rewind the tape Press 1 or turn the shuttle ring on the front panel counterclockwise when the tape is not running. To fast forward the tape Press ¡ or turn the shuttle ring on the front panel clockwise when the tape is not running. Press 5 or to select "COLOUR SYSTEM", then press 4to select the appropriate colour system. PREVIOUS PAGE S-VHS ON \COLOUR SYSTEM PAL/NTSC 2Set Colour System Mode To eject the tape Press STOP/EJECT 7/0 on the front panel. Tape Position Indicator The tape position indicator appears on screen when, from the Stop mode, you press 1, ¡ or perform an Index Search. The position of "5" in relation to "0" (beginning) or "+" (end) shows you where you are on the tape. "O. S. D. " (P. 26) must be set to "ON", or the indicator will not appear. FF To turn off the VCR Press POWER or STANDBY/ON. When playing an NTSC tape; · Some TVs shrink the picture vertically and place black bars at the top and the bottom of the TV screen. · The time counter and remaining tape length will not be correct. · The picture may roll up and down. This can be corrected using the V-HOLD control found on some TVs. (This cannot be corrected if the TV does not have a V-HOLD control). · During search, still, or frame-by frame playback, the picture will be distorted, and there may be a loss of colour. SELECT: 5 END : MENU CHANGE : 4 Each time you press 4, the setting changes as follows; a- PAL/NTSC: To record PAL signals, or playback a PAL or NTSC tape. b- MESECAM: To record SECAM signals, or play a MESECAM tape. 3Finish Setting Press MENU to exit the menu operation. B + REMAIN 2:35 1:23:45 + E Playback Make sure. . . . · Your VCR, TV, and antenna are connected correctly. · Press VCR to operate the VCR using remote control. · The correct colour mode is selected. (P. 16) Beginning End -- 21 -- BASIC OPERATIONS Recording When using this VCR, an index mark is always marked at the beginning of every recording. These index marks make it easier for you to search for the beginning of the recordings (see "Index Search" ). · The record tab on the cassette is not removed. · Your VCR, TV, and antenna are connected correctly. · Press VCR to operate the VCR using the remote control. · The correct colour mode is selected. [. . . ] · Make sure the VCR is turned on. Recording & Playback TV programme cannot be recorded. Correction · Check the connections between the VCR, the antenna, and the TV. · Make sure that the record tab on the back of the cassette is not removed. (P. 22) · Set the timer on-time and timer off-time correctly. (P. 29, P. 30) · Make sure that the VCR is turned off after setting is made. [. . . ]