User manual PHILIPS VR302

[. . . ] it contains important information and notes regarding operation. The video recorder should not be turned on immediately after transportation from a cold to a hot area or vice versa, or in conditions of extreme humidity. Wait at least three hours after transporting the device. The video recorder needs this time in order to become acclimatised to its new environment (temperature, air humidity, etc. [. . . ] When the automatic channel search function is activated, the TV channels are saved in a specific order. This may vary from the order of TV channels on the TV. This function changes the order of TV channels saved in the video recorder to match that of the TV. Make sure that the video recorder and the TV are connected by a scart cable. Repeat steps 8 to 10 until you have assigned 11. During installation, all available TV channels are searched for and saved. If the channel assignments of your cable or satellite TV provider change or if you are re-installing the video recorder, e. After moving house, you can start this procedure again. This will replace the TV channels already saved with the new ones. After you have performed the automatic channel search you may not agree with the sequence in which the individual TV channels have been allocated to the programme positions (programme numbers) of the video recorder. You can use this function to individually sort the TV channels already saved or to delete unwanted TV channels or those with poor reception. Picture/ sound quality is poor When playing rental videos or older, poorer quality cassettes, it may not be possible to completely filter out picture and sound interference. Cassettes that have been recorded in the NTSC standard (for example, American cassettes) can be played back using this video recorder. However, this only works on PAL-television sets that are suitable for a picture frequency of 60Hz. : 0:02:45 shows the counter in hours, minutes and seconds. SP/LP: will show the recorded speed of your cassette 'REM 0:06': will show the actual amount of playing/recording time left on the tape in hours and minutes. You can set the counter to '0:00:00' with CLEAR . when you put a cassette in the video recorder , the counter will automatically reset to '0:00:00'. The counter does not move This occurs when there are no recordings on a portion of a tape. This is not a fault in your video recorder. The screen shows '-0:01:20' If you rewind a cassette from the tape position '0:00:00', the counter will show for instance, '-0:01:20' (the cassette was rewound to 1 minute and 20 seconds before '0:00:00'). '-:--' is displayed in the 'REM' counter This counter will automatically recognise the length of the tape. [. . . ] This function can be used to play a cassette over and over again. When the end of the cassette is reached, the video recorder will rewind and start from the beginning again. Select line 'VCR SET UP' using K B L C 2. Blue Background on or off If you haven't used the video recorder for a few minutes in certain modes (e. [. . . ]